TSOP582.., TSOP584.., TSOP592.., TSOP594..
Vishay Semiconductors
IR Receiver Modules for Remote Control Systems
FEATURES
• Low supply current
• Photo detector and preamplifier in one package
• Internal filter for PCM frequency
• Improved shielding against EMI
• Supply voltage: 2.7 V to 5.5 V
• Improved immunity against ambient light
• Insensitive to supply voltage ripple and noise
19026
• Compliant to RoHS Directive 2002/95/EC and
in accordance to WEEE 2002/96/EC
DESCRIPTION
MECHANICAL DATA
These products are miniaturized receivers for infrared remote
control systems. A PIN diode and a preamplifier are assembled
on a lead frame, the epoxy package acts as an IR filter.
The demodulated output signal can be directly decoded by a
microprocessor. The TSOP582.., TSOP592.. series are
compatible with all common IR remote control data formats.
The TSOP584.., TSOP594, series are optimized to suppress
almost all spurious pulses from energy saving fluorescent
lamps but will also suppress some data signals.
Pinning for TSOP582.., TSOP584..:
1 = OUT, 2 = GND, 3 = VS
Pinning for TSOP592.., TSOP594..:
1 = OUT, 2 = VS, 3 = GND
This component has not been qualified according to
automotive specifications.
PARTS TABLE
STANDARD APPLICATIONS
(AGC2)
VERY NOISY ENVIRONMENTS
(AGC4)
CARRIER
FREQUENCY
PINNING
1 = OUT, 2 = GND, 3 = VS
1 = OUT, 2 = VS, 3 = GND
TSOP59230
1 = OUT, 2 = GND, 3 = VS
TSOP58430
1 = OUT, 2 = VS, 3 = GND
TSOP59430
30 kHz
33 kHz
36 kHz
36.7 kHz
38 kHz
40 kHz
56 kHz
TSOP58230
TSOP58233
TSOP58236
TSOP58237
TSOP58238
TSOP58240
TSOP58256
TSOP59233
TSOP58433
TSOP59433
TSOP59236
TSOP58436
TSOP59436
TSOP59237
TSOP58437
TSOP59437
TSOP59238
TSOP58438
TSOP59438
TSOP59240
TSOP58440
TSOP59440
TSOP59256
TSOP58456
TSOP59456
BLOCK DIAGRAM
APPLICATION CIRCUIT
17170_7
R1
C1
16833_14
Transmitter
with
TSALxxxx
IR receiver
3
1
VS
+ VS
33 kΩ
µC
OUT
GND
VO
GND
Band
pass
Demo-
dulator
Input
AGC
The external components R and C are optional
1
1
to improve the robustness against electrical overstress
(typical values are R = 100 Ω, C = 0.1 µF).
The output voltage VO should not be pulled down to a level
below 1 V by the external circuit.
2
1
1
PIN
Control circuit
The capacitive load at the output should be less than 2 nF.
** Please see document “Vishay Material Category Policy”: www.vishay.com/doc?99902
Document Number: 81221
Rev. 1.8, 04-Feb-11
www.vishay.com
1