TSOP581.., TSOP583.., TSOP591.., TSOP593..
Vishay Semiconductors
IR Receiver Modules for Remote Control Systems
FEATURES
• Low supply current
• Photo detector and preamplifier in one
package
• Internal filter for PCM frequency
• Improved shielding against EMI
• Supply voltage: 2.7 V to 5.5 V
• Suitable for short bursts: burst length 6
carrier cycles
19026
• Improved immunity against ambient light
• Insensitive to supply voltage ripple and noise
• Compliant to RoHS Directive 2002/95/EC and in
accordance to WEEE 2002/96/EC
MECHANICAL DATA
Pinning for TSOP581.., TSOP583..:
1 = OUT, 2 = GND, 3 = VS
DESCRIPTION
These products are miniaturized receiversfor infrared remote
control systems. A PIN diode and a preamplifier are assembled
on a lead frame, the epoxy package acts as an IR filter.
The demodulated output signal can directly be decoded by a
microprocessor. The main benefit of the TSOP581.., TSOP591..
is the compatibility to all IR remote control data formats. The
TSOP583.., TSOP593 are optimized to better suppress
spurious pulses from fluorescent lamps, LCD TVs or plasma
displays.
Pinning for TSOP591.., TSOP593..:
1 = OUT, 2 = VS, 3 = GND
This component has not been qualified according to
automotive specifications.
PARTS TABLE
SHORT BURST AND HIGH DATA RATE
(AGC1)
NOISY ENVIRONMENTS AND SHORT BURSTS
(AGC3)
CARRIER
FREQUENCY
PINNING
1 = OUT, 2 = GND, 3 = VS
TSOP58130
1 = OUT, 2 = VS, 3 = GND
TSOP59130
1 = OUT, 2 = GND, 3 = VS
TSOP58330
1 = OUT, 2 = VS, 3 = GND
TSOP59330
30 kHz
33 kHz
36 kHz
38 kHz
40 kHz
56 kHz
TSOP58133
TSOP58136
TSOP58138
TSOP58140
TSOP58156
TSOP59133
TSOP59136
TSOP59138
TSOP59140
TSOP59156
TSOP58333
TSOP59333
TSOP58336
TSOP59336
TSOP58338
TSOP59338
TSOP58340
TSOP59340
TSOP58356
TSOP59356
BLOCK DIAGRAM
16833_14
APPLICATION CIRCUIT
17170_7
R1
Transmitter
with
TSALxxxx
IR receiver
3
1
VS
+ VS
GND
C1
33 kΩ
µC
OUT
GND
VO
Band
pass
Demo-
dulator
Input
AGC
The external components R and C are optional
1
1
to improve the robustness against electrical overstress
2
(typical values are R = 100 Ω, C = 0.1 µF).
PIN
1
1
Control circuit
The output voltage VO should not be pulled down to a level
below 1 V by the external circuit.
The capacitive load at the output should be less than 2 nF.
** Please see document “Vishay Material Category Policy”: www.vishay.com/doc?99902
Document Number: 81398
Rev. 1.7, 04-Feb-11
www.vishay.com
1