5秒后页面跳转
TRF6900APTR PDF预览

TRF6900APTR

更新时间: 2024-01-21 22:48:30
品牌 Logo 应用领域
德州仪器 - TI 电信集成电路蜂窝电话电路电信电路射频
页数 文件大小 规格书
35页 511K
描述
SINGLE-CHIP RF TRANSCEIVER

TRF6900APTR 技术参数

是否无铅:含铅是否Rohs认证:不符合
生命周期:Obsolete零件包装代码:QFP
包装说明:PLASTIC, LQFP-48针数:48
Reach Compliance Code:not_compliantHTS代码:8542.39.00.01
Factory Lead Time:1 week风险等级:5.73
Is Samacsys:NJESD-30 代码:S-PQFP-G48
长度:7 mm功能数量:1
端子数量:48最高工作温度:60 °C
最低工作温度:-20 °C封装主体材料:PLASTIC/EPOXY
封装代码:LFQFP封装等效代码:QFP48,.35SQ,20
封装形状:SQUARE封装形式:FLATPACK, LOW PROFILE, FINE PITCH
峰值回流温度(摄氏度):NOT SPECIFIED电源:2.2/3.6 V
认证状态:Not Qualified座面最大高度:1.6 mm
子类别:Other Telecom ICs表面贴装:YES
技术:CMOS电信集成电路类型:RF AND BASEBAND CIRCUIT
温度等级:COMMERCIAL端子形式:GULL WING
端子节距:0.5 mm端子位置:QUAD
处于峰值回流温度下的最长时间:NOT SPECIFIED宽度:7 mm
Base Number Matches:1

TRF6900APTR 数据手册

 浏览型号TRF6900APTR的Datasheet PDF文件第1页浏览型号TRF6900APTR的Datasheet PDF文件第3页浏览型号TRF6900APTR的Datasheet PDF文件第4页浏览型号TRF6900APTR的Datasheet PDF文件第5页浏览型号TRF6900APTR的Datasheet PDF文件第6页浏览型号TRF6900APTR的Datasheet PDF文件第7页 
TRF6900A  
SINGLE-CHIP RF TRANSCEIVER  
SLAS258D SEPTEMBER 2000 REVISED SEPTEMBER 2001  
description  
The TRF6900A single-chip solution is an integrated circuit intended for use as a low cost FSK transceiver to  
establish a frequency-agile, half-duplex, bidirectional RF link. The device is available in a 48-lead TQFP  
packageandisdesignedtoprovideafully-functionalmultichannelFMtransceiver. Thechipisintendedforlinear  
(FM) or digital (FSK) modulated applications in the new 868-MHz European band and the North American  
915-MHz ISM band. The single chip transceiver operates down to 2.2 V and is expressly designed for low power  
consumption. The synthesizer has a typical channel spacing of approximately 230 Hz to allow narrow-band as  
well as wide-band application. Due to the narrow channel spacing of the direct digital synthesizer (DDS), the  
DDS can be used to adjust the TX/RX frequency and allows the use of inexpensive reference crystals.  
Two fully-programmable operation modes, Mode0 and Mode1, allow extremely fast switching between two  
preprogrammed settings (e.g., receive(RX)/transmit(TX); TX_frequency_0/TX_frequency_1;  
RX_frequency_0/RX_frequency_1;) without reprogramming the device. Each functional block of the  
transceiver can be specifically enabled or disabled via the serial interface.  
ISM band standards  
Europe has assigned a new unlicensed frequency band of 868 MHz to 870 MHz. This new band is specifically  
defined for short range devices with duty cycles from 0.1% to 100% in several sub-bands. The existing 433-MHz  
band for short-range devices in Europe has the great disadvantage of very high usage. The new European  
frequency band, due to the duty cycle assignment, allows a reliable RF link and makes many new applications  
possible.  
The North American unlicensed ISM (industrial, scientific, and medical) band covers 902 MHz to 928 MHz  
(center frequency of 915 MHz), and is suitable for short range RF links.  
transmitter  
The transmitter consists of an integrated VCO, a complete fully-programmable direct digital synthesizer, and  
a power amplifier. The internal VCO can be used with an external tank circuit or an external VCO. The divider,  
prescaler, and reference oscillator require only the addition of an external crystal and a loop filter to provide a  
complete DDS with a typical frequency resolution of 230 Hz.  
The 8-bit FSK frequency deviation register determines the frequency deviation in FSK mode. The modulation  
itself is done in the direct digital synthesizer, hence no additional external components are necessary.  
Since the typical RF output power is approximately 4.5 dBm, no additional external RF power amplifier is  
necessary in most applications.  
receiver  
The integrated receiver is intended to be used as a single-conversion FSK receiver. It consists of a low-noise  
amplifier, mixer, IF amplifier, limiter, FM/FSK demodulator with an external LC tank circuit, and a data slicer. The  
receive strength signal indicator ( RSSI ) can be used for fast carrier sense detection or as an on/off keying,  
or amplitude shift keying, (OOK/ASK) demodulator. In the learning mode, during a learning sequence  
(0,1,0,1,0,....), the initial tolerances of the LC demodulator tank circuit are compensated and an external  
capacitor is charged to a dc voltage that is proportional to the average demodulation dc level. This level is the  
zero reference for the data slicer to generate the logical levels of the data sequence that follow the learning  
sequence. Using the internal data switch, the demodulated OOK and FSK signals are available at the same  
DATA_OUT terminal.  
baseband interface  
The TRF6900A can easily be interfaced to a baseband processor such as the Texas Instruments MSP430  
ultralow-power microcontroller (see Figure 1). The TRF6900A serial control registers are programmed by the  
MSP430 and the MSP430 performs baseband operations in software.  
2
POST OFFICE BOX 655303 DALLAS, TEXAS 75265  

与TRF6900APTR相关器件

型号 品牌 描述 获取价格 数据表
TRF6900PT TI RF Modulator/Demodulator

获取价格

TRF6900PTR TI 暂无描述

获取价格

TRF6901 TI SINGLE-CHIP RF TRANSCEIVER

获取价格

TRF6901PTR TI 暂无描述

获取价格

TRF6901PTRG4 TI TELECOM, CELLULAR, RF AND BASEBAND CIRCUIT, PQFP48, GREEN, PLASTIC, LQFP-48

获取价格

TRF6903 TI SINGLE CHIP MULTIBAND RF TRANSCEIVER

获取价格