TPS71319
TPS71334
A ct ual S i ze
(3 m m x 3 m m )
www.ti.com
SBVS055A–DECEMBER 2004–REVISED JANUARY 2005
Dual 250 mA Output, UltraLow Noise, High PSRR,
Low-Dropout Linear Regulator with Integrated SVS
FEATURES
DESCRIPTION
•
Dual 250 mA High-Performance RF LDOs
The TPS713xx family of low-dropout (LDO) voltage
regulators is tailored to noise-sensitive and RF appli-
cations. These products feature dual 250 mA LDOs
with ultralow noise, high power-supply rejection ratio
(PSRR), and fast transient and start-up response.
These devices also feature an integrated supply
voltage supervisor (SVS) that monitors the voltage at
OUT2 and will assert if the voltage falls to 95%
(typical) of the measured output. Each regulator
output is stable with low-cost 2.2 µF ceramic output
capacitors and features very low dropout voltages
(125 mV typical at 250 mA). Each regulator achieves
fast start-up times (approximately 60 µs with a
0.001 µF bypass capacitor) while consuming very low
quiescent current (300 µA typical with both outputs
enabled). When the device is placed in standby
mode, the supply current is reduced to less than
0.3 µA typical. Each regulator exhibits approximately
32 µVrms of output voltage noise with VOUT = 2.8 V
and a 0.01 µF noise reduction (NR) capacitor. Appli-
•
Integrated Supply Voltage Supervisor
Monitors VOUT2
•
Available in Fixed and Adjustable
Voltage Options (1.2 V to 5.5 V)
•
•
•
•
•
•
•
•
High PSRR: 65 dB at 10 kHz
UltraLow Noise: 32 µVrms
Fast Start-Up Time: 60 µs
Stable with 2.2 µF Ceramic Capacitor
Excellent Load/Line Transient Response
Very Low Dropout Voltage: 125 mV at 250 mA
Independent Enable Pins
Thermal Shutdown and Independent Current
Limit
•
Available in Thermally-Enhanced SON
Package: 3mm x 3mm x 1mm
cations with analog components
that
are
APPLICATIONS
noise-sensitive, such as portable RF electronics, will
benefit from high PSRR, low noise, and fast line and
load transient features. The TPS713xx family is
offered in a thin 3mm x 3mm SON package and is
fully specified from -40°C to +125°C (TJ).
•
•
•
•
•
Cellular and Cordless Phones
Wireless PDA/Handheld Products
PCMCIA/Wireless LAN Applications
Digital Camera/Camcorder/Internet Audio
DSP/FPGA/ASIC/Controllers and Processors
PSRR (RIPPLE REJECTION) vs FREQUENCY
80
70
60
50
40
30
20
10
0
IOUT = 250 mA
DRC PACKAGE
3mm x 3mm SON
(TOP VIEW)
IN
RESET
OUT1
OUT2
GND
1
2
3
4
5
10 EN1
9
8
7
6
NC
IOUT = 1 mA
EN2
FB2/NC
NR
VOUT = 2.8 V (adj)
µ
COUT = 2.2
CNR = 0.01
F
µ
F
10
100
1k
10k
100k
1M
10M
Frequency (Hz)
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2004–2005, Texas Instruments Incorporated