TPS40303, TPS40304, TPS40305
www.ti.com
SLUS964 –NOVEMBER 2009
3-V TO 20-V INPUT SYNCHRONOUS BUCK CONTROLLER
Check for Samples :TPS40303 TPS40304 TPS40305
1
FEATURES
CONTENTS
•
Input Voltage Range from 3 V to 20 V
Device Ratings
2
3
•
300 KHz (TPS40303), 600 KHz (TPS40304) and
1.2 MHz (TPS40305) Switching Frequencies
Electrical Characteristics
Device Information
Application Information
Design Examples
Additional References
X
8
•
•
High- and Low-Side FET RDS(on) Current
Sensing
10
14
24
Programmable Thermally Compensated OCP
Levels
•
•
•
•
•
•
•
Programmable Soft-Start
600 mV, 1% Reference Voltage
Voltage Feed-Forward Compensation
Supports Pre-Biased Output
APPLICATIONS
•
•
•
•
POL Modules
Printer
Digital TV
Telecom
Frequency Spread Spectrum
Thermal Shutdown Protection at 145°C
10-Pin 3 mm × 3 mm SON Package with
Ground Connection to Thermal Pad
DESCRIPTION
The TPS4030x is a family of cost-optimized synchronous buck controllers that operate from 3-V to 20-V input.
The controller implements a voltage-mode control architecture with input-voltage feed-forward compensation that
responds instantly to input voltage change. The switching frequency is fixed at 300 KHz, 600 KHz or 1.2 MHz.
Frequency Spread Spectrum feature adds dither to the switching frequency, significantly reducing the peak EMI
noise and making it much easier to comply with EMI standards.
The TPS4030x offers design with a variety of user programmable functions, including soft-start, Over- Current
Protection (OCP) levels, and loop compensation.
OCP level may be programmed by a single external resistor connected from LDRV pin to circuit ground. During
initial power on, the TPS4030x enters a calibration cycle, measures the voltage at the LDRV pin, and sets an
internal OCP voltage level. During operation, the programmed OCP voltage level is compared to the voltage drop
across the low side FET when it is on to determine whether there is an overcurrent condition. The TPS4030x
then enters a shutdown and restart cycle until the fault is removed.
SIMPLIFIED APPLICATION DIAGRAM
V
OUT
V
TPS4030x
IN
5
4
3
2
1
FB
BOOT
HDRV
SW
6
7
8
9
COMP
V
OUT
PGOOD
EN/SS LDRV/OC
SD
V
VDD
BP 10
GND
PAD
IN
UDG-09158
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2009, Texas Instruments Incorporated