TP1511/TP1511N/TP1512/TP1514
Stable 150kHz, 4μA, Rail-to-Rail, EveryCapTM Op Amps
Features
Description
TP151x series are CMOS single/dual/quad op-amps
with low offset, stable high frequency response, low
power, low supply voltage, and rail-to-rail inputs and
outputs. They incorporate 3PEAK’s proprietary and
patented design techniques to achieve best in-class
performance among all micro-power CMOS
amplifiers in its power class. The TP151x family can
be used as plug-in replacements for many
Stable 150kHz GBWP Over Temperature Range
Stable 150kHz GBWP in VCM from 0-V to VDD
0.09V/μs Slew Rate
Only 4μA of Supply Current per Amplifier
Shutdown Current: 0.1μA (TP1511N)
Up to 55 Years Operation from 2 AA Alkaline-Cells
Unity Gain Stable for ANY CAPACITIVE Load
Offset Voltage: 3.0mV Maximum
commercially available op-amps to reduce power
and improve input/output range and performance.
TP151x are unity gain stable with Any Capacitive
load with a constant 150kHz GBWP, 0.09V/μs slew
rate while consuming only 4μA of quiescent current
per amplifier. Analog trim and calibration routine
reduce input offset voltage to below 3.0mV, and
proprietary precision temperature compensation
technique makes offset voltage temperature drift at
0.6μV/°C. Beyond the rails input and rail-to-rail
output characteristics allow the full power-supply
voltage to be used for signal range.
Offset Voltage Temperature Drift: 0.6 μV/°C
Input Bias Current: 1pA Typical
High CMRR/PSRR: 110dB
No Phase Reversal for Overdriven Inputs
Beyond the Rails Input Common-Mode Range
Outputs Swing to within 5mV of Each Rail
Single +2.1V to +6.0V Supply Voltage Range
–40°C to 125°C Operation Range
This combination of features makes the TP151x
OPA ideal choices for battery-powered applications
because they minimize errors due to power supply
voltage variations over the lifetime of the battery and
maintain high CMRR even for a rail-to-rail input
op-amp. Battery Current Monitor, consumer devices,
handheld instrumentation, Remote battery-powered
sensors, hazard detection (for example, smoke, fire,
and gas), and patient monitors can benefit from the
features of the TP151x op-amps.
ESD Rating:
Robust 8KV – HBM, 2KV – CDM and 500V – MM
Green, Popular Type Package
Applications
Sensor Conditioning
Battery Current Sensing
IR thermometers
For applications that require power-down, the
TP1511N in popular type packages has a low-power
shutdown mode that reduces supply current to less
Digital Scales
than 0.1μA, and forces the output into
a
Automotive Keyless Entry
Toll Booth Tags
high-impedance state.
Data Acquisition Equipment
Battery or Solar Powered Systems
Active Filters, ASIC Input or Output Amplifier
Portable Instruments
3PEAK and the 3PEAK logo are registered trademarks of
3PEAK INCORPORATED. All other trademarks are the property
of their respective owners.
VDD
R4
R1
R2
LOAD
R3
IN+
IN-
VOUT
TP1511
RSENSE
Figure 1. TP1511 in Battery Monitoring Application
www.3peakic.com.cn
REV A
1