TMC150 Series
150 WattsAC/DC Medical & ITE Grade Power Supplies
FEATURES
• 2" x 4" x 1.2" Open Frame
• Low Leakage Current
• BF Rated Outputs
• Remote Sense & Optional PFD
• 0.5W No Load Power Consumption
MODELS LIST
GENERAL SPECIFICATIONS
Switching Frequency ............. 133 kHz typical
Maximum Output Power (2)
Power Factor ......................... 0.98 typical, with active PFC
Efficiency ............................... 87% typical @ 115 VAC,
89% typical @ 230 VAC
Output
Voltage
Product No.(1)
@ Convection
@ 7.5 CFM
Hold-up Time......................... 10 ms min. @ 120 VAC
Operating Altitude .................. 5,000 meters max.
Line Regulation..................... ±0.5% max. @ full load
Current Wattage Current Wattage
TMC150-S12
TMC150-S15
TMC150-S18
TMC150-S24
TMC150-S30
TMC150-S36
12V
15V
18V
24V
30V
36V
48V
8.35A
6.7A
100W
100W
100W
100W
100W
100W
100W
12.5A
10A
150W
150W
150W
150W
150W
150W
150W
°
°
Operating Temperature ........ 0 C to +70 C
°
Derating................................. Derate from 100% @ +50 C
°
linearly to 50% @ +70 C,
5.56A
4.2A
8.34A
6.25A
5A
applicable to convection and
forced-air cooling conditions
°
°
Storage Temperature ............ -40 C to +85 C
Relative Humidity .................. 5% to 95% non-condensing
Withstand Voltage ................. 4,000 VAC, input-output (2 MOPP)
1,500 VAC, input-ground (1 MOPP)
3.34A
2.78A
2.1A
4.17A
3.13A
TMC150-S48
1,500 VAC, output-ground
MTBF ......................................250 kHrs minimum at full load,
Notes:
°
25 C ambient, calculated per
MIL-HDBK-217F
1. Add suffix F to the P/N to order units with PFD, e.g. TMC150-S24F.
2. 168W peak power with 10% duty cycle maximum for less than 15 seconds with
the average output not to exceed the maximum power rating.
STANDARDS & COMPLIANCES
INPUT SPECIFICATIONS
EN55011, EN55022 .......... Class B conducted, Class A radiated
FCC.................................... Class B conducted, Class A radiated
VCCI ................................... Class B conducted, Class A radiated
EN61000-3-2..................... Harmonic distortion, Class A & D
EN61000-3-3..................... Line flicker
EN61000-4-2..................... ESD, ±8 KV air and ±6 KV contact
EN61000-4-3..................... Radiated immunity, 3V/m
EN61000-4-4..................... Fast transient/burst, ±2 KV
EN61000-4-5..................... Surge, ±1 KV diff., ±2 KV com.
EN61000-4-6..................... Conducted immunity, 3 Vrms
EN61000-4-8..................... Magnetic field immunity, 3A/m
EN61000-4-11 ................... Voltage dips immunity,
30% reduction for 500ms,
Input Voltage Range .............. 90-264 VAC
Input Frequency ..................... 47-63 Hz
Input Current .......................... 1.7A rms @ 115 VAC,
0.85A rms @ 230 VAC
Inrush Current ....................... 80A @115VACor160A@ 230 VAC,
°
at 25 C cold start
Earth Leakage Current .......... 105 µA max. @ 264 VAC, 63 Hz
OUTPUT SPECIFICATIONS
Output Power Ratings ........... See table
Minimum Load ...................... Not required
Tolerance ............................... ±2%
Ripple and Noise* ................. 1% Vp-p, 20 MHz bandwidth
Remote Sense ...................... Compensates cable losses up
to 0.5V
60% reduction for 100ms,
>95% reduction for 10ms
Safety Standards ............... IEC/EN 60601-1 (3rd Edition),
ANSI/AAMI ES 60601-1:2005,
Overvoltage Protection .......... Set at 112-140% of its nominal
output voltage
CSA C22.2 No. 60601-1:08;
Overcurrent Protection .......... Protected to short-circuit
conditions
UL/IEC/EN 60950-1 (2nd Edition),
CSA C22.2 No. 60950-1 (2nd Edition)
°
Temperature Coefficient ....... ±0.04%/ C max.
AgencyApprovals .............. UL, cUL, TUV, CB, CE
Other Compliance ............. RoHS
Transient Response............. Max. excursion of 4% or better on
all models, recovering to 1% of
final value within 500 µs after a
25% step load change
No Load Power Cons. .......... <0.5W w/o PFD, <1W with PFD
* Measured with a 10µF tantalum capacitor in parallel with a 0.1µF ceramic capacitor
at rated line voltage and load ranges.
Tumbler Technologies + TRUMPower
3350 Scott Blvd., Building 13 • Santa Clara, California 95054, USA • 408-988-6616 • sales@trumpower.com • www.TRUMPower.com