TLV9001, TLV9002, TLV9004
SBOS833R – OCTOBER 2017 – REVISED NOVEMBER 2021
TLV900x Low-Power, RRIO, 1-MHz Operational Amplifier for Cost-Sensitive Systems
The TLV900x devices include a shutdown mode
(TLV9001S, TLV9002S, and TLV9004S) that allow the
1 Features
•
•
•
•
•
•
•
•
•
•
•
Scalable CMOS amplifier for low-cost applications
Rail-to-rail input and output
Low input offset voltage: ±0.4 mV
Unity-gain bandwidth: 1 MHz
Low broadband noise: 27 nV/√Hz
Low input bias current: 5 pA
Low quiescent current: 60 µA/Ch
Unity-gain stable
amplifiers to switch off into standby mode with typical
current consumption less than 1 µA.
Micro-size packages, such as SOT-553 and WSON,
are offered for all channel variants (single, dual, and
quad), along with industry-standard packages such as
SOIC, MSOP, SOT-23, and TSSOP packages.
Device Information
PART NUMBER(1)
PACKAGE
BODY SIZE (NOM)
1.60 mm × 2.90 mm
1.25 mm × 2.00 mm
1.65 mm × 1.20 mm
0.80 mm × 0.80 mm
1.60 mm × 2.90 mm
1.25 mm × 2.00 mm
3.91 mm × 4.90 mm
2.00 mm × 2.00 mm
3.00 mm × 3.00 mm
1.60 mm × 2.90 mm
3.00 mm × 4.40 mm
3.00 mm × 3.00 mm
1.50 mm × 2.00 mm
1.00 mm × 1.00 mm
8.65 mm × 3.91 mm
4.20 mm × 2.00 mm
4.40 mm × 5.00 mm
3.00 mm × 3.00 mm
2.00 mm × 2.00 mm
3.00 mm × 3.00 mm
Internal RFI and EMI filter
Operational at supply voltages as low as 1.8 V
Easier to stabilize with higher capacitive load due
to resistive open-loop output impedance
Extended temperature range: –40°C to 125°C
SOT-23 (5)
SC70 (5)
TLV9001
SOT-553 (5)(2)
X2SON (5)
SOT-23 (6)
SC70 (6)
•
2 Applications
TLV9001S
TLV9002
•
•
•
•
•
•
•
•
•
•
•
•
•
Sensor signal conditioning
Power modules
Active filters
Low-side current sensing
Smoke detectors
Motion detectors
Wearable devices
Large and small appliances
EPOS
SOIC (8)
WSON (8)
VSSOP (8)
SOT-23 (8)
TSSOP (8)
VSSOP (10)
X2QFN (10)
DSBGA (9)
SOIC (14)
TLV9002S
Barcode scanners
Personal electronics
HVAC: heating, ventilating, and air conditioning
Motor control: AC induction
SOT-23 (14)
TSSOP (14)
WQFN (16)
X2QFN (14)
WQFN (16)
TLV9004
3 Description
The TLV900x family includes single (TLV9001), dual
(TLV9002), and quad-channel (TLV9004) low-voltage
(1.8 V to 5.5 V) operational amplifiers (op amps)
with rail-to-rail input and output swing capabilities.
These op amps provide a cost-effective solution
for space-constrained applications such as smoke
detectors, wearable electronics, and small appliances
where low-voltage operation and high capacitive-load
drive are required. The capacitive-load drive of the
TLV900x family is 500 pF, and the resistive open-
loop output impedance makes stabilization easier with
much higher capacitive loads. These op amps are
designed specifically for low-voltage operation (1.8 V
to 5.5 V) with performance specifications similar to the
TLV600x devices.
TLV9004S
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
(2) Package is for preview only.
The robust design of the TLV900x family simplifies
circuit design. The op amps feature unity-gain
stability, an integrated RFI and EMI rejection filter, and
no-phase reversal in overdrive conditions.
Single-Pole, Low-Pass Filter
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.