TLI4971 high precision coreless current sensor for industrial
applications in 8x8mm SMD package
Description
Features & Benefits
TLI4971 is a high precision miniature coreless
magnetic current sensor for AC and DC
measurements with analog interface and two fast
over-current detection outputs.
Integrated current rail with typical 225µΩ insertion
resistance enables ultra-low power loss
Smallest form factor, 8x8mm SMD, for easy
integration and board area saving
Infineon's well-established and robust monolithic
Hall technology enables accurate and highly linear
measurement of currents with a full scale up to
±120A. All negative effects (saturation, hysteresis)
commonly known from open loop sensors using
flux concentration techniques are avoided. The
sensor is equipped with internal self-diagnostic
feature.
Typical applications are electrical drives (up to
690V), current monitoring, chargers, photovoltaic
inverters, general purpose inverters, overload and
over-current detection.
Single supply voltage, 3.1V to 3.5V
High accurate, scalable, DC & AC current sensing
Full scale up to ±120A
Bandwidth greater than 120kHz enables wide range
of applications
Low phase delay (< 48° at below 120kHz) for easy
closed loop control
Very low sensitivity error over temperature (< 2.5%)
Excellent stability of offset over temperature and
lifetime
Integrated isolator provides high robustness to
voltage slew rates up to 10V/ns
The digitally assisted analog concept of TLI4971
offers superior stability over temperature and
lifetime thanks to the proprietary digital stress and
temperature compensation. The differential
measurement principle allows great stray field
suppression for operation in harsh environments.
The integrated primary conductor (current rail)
with very low insertion resistance minimizes the
power loss and enables miniaturization of sensing
circuitry. A small 8mm x 8mm leadless package
(QFN-like) allows for standard SMD assembly.
Two separate interface pins (OCD) provide a fast
output signal in case a current exceeds a pre-set
threshold.
Galvanic functional isolation up to 1150V peak VIORM
VISO 2500V RMS agency type-tested for 60 seconds
per UL1577
Partial discharge capability of at least 1200V
Differential sensor principle ensures superior
magnetic stray field suppression
Two independent fast Over-Current Detection (OCD)
pins with configurable thresholds enable protection
mechanisms for power circuitry (typical 0.7µs)
Ratiometric and non ratiometric analog output
Fully calibrated
s
The sensor is shipped as a fully calibrated product
without requiring any customer end-of-line
calibration.
Nevertheless, the high configurability enables
individual customization for a wide variety of
applications. All user-programmable parameters
such as OCD thresholds, blanking times and output
configuration modes are stored in an embedded
EEPROM memory. Programming of the memory can
be performed in the application through a Serial
Inspection and Configuration Interface (SICI).
Coreless current sensor in PG-TISON-8 package
Order Information
Ordering
Number
Product Name
Product Type
Package
TLI4971-A120T5-U-E0001 120A measurement range, UL certified device 1)2)
PG-TISON-8 SP005272936
TLI4971-A120T5-E0001
120A measurement range 1)2)
PG-TISON-8 SP005344532
1) Current sensor for industrial / consumer applications, qualified according to AEC Q100 grade 2
2) Semi-differential mode, non-ratiometric output sensitivity
Datasheet
www.infineon.com
Please read the Important Notice and Warnings at the end of this document
Revision 1.1
09-03-2020