TL16PNP100A
STANDALONE PLUG-AND-PLAY (PnP) CONTROLLER
SLLS200C – MARCH 1995 – REVISED SEPTEMBER 1997
FN PACKAGE
(TOP VIEW)
PnP Card Autoconfiguration Sequence
Compliant
Supports Two Logical Devices
Decodes 10-Bit I/O Address Location With
Programmable 1-, 2-, 4-, 8-, 16-Byte Block
Size
6
5
4
3
2
1 44 43 42 41 40
39
D0
D1
D2
D3
A6
7
Maps Interrupts to Six Interrupt Outputs
IRQ3–IRQ7 and IRQ9
A7
8
38
37
36
35
34
A8
9
Provides Simple 3-Terminal Interface to
SGS-Thomson EEPROM 2K/4K ST93C56/66
or Equivalent
A9
10
GND 11
D4 12
A10
A11
13
14
15
16
17
3-State Output EEPROM Interface Allows
the EEPROM to be Accessed by Another
Controller
D5
D6
33 GND
32 CLK
31
30
29
D7
INTR0
CS0
GND
IRQ3
Provides Direct Connection to ISA/AT Bus
EEPROM
Data and Interrupt Signals Require No
Buffer
18 19 20 21 22 23 24 25 26 27 28
Available in 44-Pin Plastic Leaded Chip
Carrier (PLCC) and 48-Pin TQFP Package
description
PT PACKAGE
(TOP VIEW)
The TL16PNP100A responds to the plug-and-
play (PnP) autoconfiguration process. The
process puts all PnP cards in a configuration
mode, isolates one PnP card at a time, assigns a
card-select number (CSN), and reads the card
resource-data structure from the ST93C56/66
EEPROM. After the resource requirements and
capabilities are determined for all cards, the
process uses the CSN to configure the card by
writing to the configuration registers. The
TL16PNP100A implements configuration regis-
ters only for I/O applications with two logical
devices, and DMA application support is not
provided. Finally, the process activates the
TL16PNP100A card and removes it from
configuration mode. After the configuration
process, the logic function can then start
responding to industry standard architecture
(ISA) bus cycles. The controller disables the
EEPROM interface after the configuration is
complete to allow another on-board controller to
access the EEPROM.
48 47 46 45 44 43 42 41 40 39 38 37
36
35
34
33
32
31
30
29
28
27
26
25
A6
A7
A8
A9
NC
A10
A11
GND
CLK
INTR0
CS0
EEPROM
D0
D1
D2
D3
GND
D4
NC
D5
D6
1
2
3
4
5
6
7
8
9
D7 10
GND
IRQ3
11
12
13 14 15 16 17 18 19 20 21 22 23 24
NC – No internal connection
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
Copyright 1997, Texas Instruments Incorporated
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
1
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265