Datasheet > TDA8595TH/N2,518

TDA8595TH/N2,518

更新时间： 2024-10-29 10:07:03

品牌	Logo	应用领域
恩智浦 - NXP		/
页数	文件大小	规格书
51页	478K
描述
TDA8595 - I²C-bus controlled 4 x 45 W power amplifier SOIC 36-Pin

阅读下载

中文翻译

获取价格

数据手册

如果您发现信息不准确，欢迎纠错

TDA8595TH/N2,518 数据手册

TDA8595

I²C-bus controlled 4  45 W power amplifier

Rev. 5 — 11 June 2013

Product data sheet

1. General description

The TDA8595 is a complementary quad Bridge Tied Load (BTL) audio power amplifier

made in BCDMOS technology. It contains four independent amplifiers in BTL

configuration. Through the I²C-bus, diagnosis of temperature warning and clipping level is

fully programmable and the information available via two diagnostic pins is selectable.

The status of each amplifier (output offset, load or no load, short-circuit or speaker

incorrectly connected) can be read separately.

2. Features and benefits

2.1 General

 Operates in legacy mode (non I²C-bus) and I²C-bus mode (3.3 V and 5 V compliant)

 Three hardware-programmable I²C-bus addresses

 Drive 4  or 2  loads

 Speaker fault detection

 Independent short-circuit protection per channel

 Loss of ground and open V_Psafe (with 150 m series impedance and a supply

decoupling capacitor of 2200 F maximum)

 All outputs short-circuit proof to ground, supply voltage and across the load

 All pins short-circuit proof to ground

 Temperature-controlled gain reduction to prevent audio holes at high junction

temperatures

 Low battery voltage detection

 Offset detection

 This part has been qualified in accordance with AEC-Q100

2.2 I²C-bus mode

 DC load detection: open-circuit, short-circuit and load present

 AC load (tweeter) detection

 During start-up, can detect which load is connected so the appropriate gain can be

selected without audio pop

 Independently selectable soft mute of front channels (channel 1 and channel 3) and

rear channels (channel 2 and channel 4)

 Programmable gain (26 dB and 16 dB) of front channels and rear channels

 Fully programmable diagnostic levels can be set:

 Programmable clip detection: 2 %, 5 % or 10 %

 Programmable thermal pre-warning

12 3 4 5 6 7...51

中文翻译

下载PDF

与TDA8595TH/N2,518相关器件

型号	品牌	获取价格	描述	数据表
TDA8595TH/N2/R4,51	NXP	获取价格	TDA8595 - I²C-bus controlled 4 x 45 W power a
TDA8595TH/N2C,112	NXP	获取价格	TDA8595 - I²C-bus controlled 4 x 45 W power a
TDA8595TH/N2C,118	NXP	获取价格	TDA8595 - I²C-bus controlled 4 x 45 W power a
TDA8596TH/N1,118	NXP	获取价格	TDA8596 - I2C-bus controlled 4 x 45 W power amplifier with symmetrical inputs SOIC 36-Pin
TDA8596TH/N1S,118	NXP	获取价格	TDA8596 - I2C-bus controlled 4 x 45 W power amplifier with symmetrical inputs SOIC 36-Pin
TDA8601	NXP	获取价格	RGB/YUV and fast blanking switch
TDA8601N	NXP	获取价格	IC 2-CHANNEL, AUDIO/VIDEO SWITCH, PDIP16, Multiplexer or Switch
TDA8601T	NXP	获取价格	RGB/YUV and fast blanking switch
TDA8601T/C2	PHILIPS	获取价格	Audio/Video Switch, BIPolar, PDSO16,
TDA8702	NXP	获取价格	8-bit video digital-to-analog converter