TDA8034HN
Low power smart card interface
Rev. 3.4 — 29 June 2016
Product data sheet
1. General description
The TDA8034HN is a cost-effective analog interface for asynchronous and synchronous
smart cards operating at 5 V, 3 V or 1.8 V. Using few external components, the
TDA8034HN provides all supply, protection and control functions between a smart card
and the microcontroller.
2. Features and benefits
Integrated circuit smart card interface in an HVQFN24 package
5 V, 3 V or 1.8 V smart card supply
Very low power consumption in Deep Shutdown mode
Three protected half-duplex bidirectional buffered I/O lines (C4, C7 and C8)
VCC regulation:
5 V, 3 V or 1.8 V 5 % using two low ESR multilayer ceramic capacitors: one of
220 nF and one of 470 nF
current spikes of 40 nA/s (VCC = 5 V and 3 V) or 15 nA/s (VCC =1.8 V) up to
20 MHz, with controlled rise and fall times and filtered overload detection of
approximately 120 mA
Thermal and short-circuit protection for all card contacts
Automatic activation and deactivation sequences triggered by a short-circuit, card
take-off, overheating, falling VDD, VDD(INTF) or VDDP
Enhanced card-side ElectroStatic Discharge (ESD) protection of > 8 kV
External clock input up to 26 MHz connected to pin XTAL1
Card clock generation up to 20 MHz using pins CLKDIV1 and CLKDIV2 with
synchronous frequency changes of fxtal, 1⁄2 fxtal, 1⁄4 fxtal or 1⁄8 fxtal
Non-inverted control of pin RST using pin RSTIN
Compatible with ISO 7816, NDS and EMVCo4.3 1 payment systems
Supply supervisor for killing spikes during power on and off:
using a fixed threshold
using an external resistor bridge with threshold adjustment
Built-in debouncing on card presence contacts (typically 8 ms)
Multiplexed status signal using pin OFFN
1. For C2 version