TCM8230MD (A) Ver. 1.20
TOSHIBA CMOS DIGITAL INTEGRATED CIRCUIT SILICON MONOLITHIC
TCM8230MD (A)
TENTATIVE
VGA CAMERA MODULE
The TCM8230MD(A) is a camera module which includes area color image sensor embedded with camera signal
processor that meets with VGA format. In the sensor area 492 vertical and 660 horizontal signal pixels, and the image
size meets with 1/6 inch optical Format. Use of the CMOS process enables low power consumption operations. It
also provides excellent color reproduction through its primary color filter, and embedded camera signal processor
enables small and simple camera system. And this module can be assembled by the socket which is suitable for the
reflow soldering. So it is fit to use as an image input device for digital still cameras, PC cameras and mobile devices.
Features
1. General
•
•
•
•
Module size : 6(W) x 6(D) x 4.5(H) mm
I2C BUS I/F
Sleep mode operation (It can be controlled by the I2C Bus command)
Power supply : 2.8+/-0.2V or 2.5+/-0.2V (Sensor(photo diode), I/O) and 1.5+/-0.1V(Sensor(A/D converter), Digital)
2. Sensor
• Optical size
: 1/6 inch optical format
• Total pixel numbers : 698(H)x502(V)
• Signal pixel numbers : 660(H)x492(V)
• Pixel pitch
• Color filter
• Frame rate
: 3.75um(H)x3.75um(V) (square pixel)
: RGB color filter, Bayer arrangement (GR line and GB line are arranged alternately.)
: Max 30fps
• Raw data bit precision : 10bit
• Feed back clamp
3. Camera signal processing
• Maximum exposure time can be adjust from 1V to 15V
• Digital outputs
YUV=4:2:2 or RGB=5:6:5 ( 8bit parallel output )
• Picture size
VGA, QVGA, QQVGA, CIF, QCIF, subQCIF ( Sub-sampling , Windowing )
• Readout internal parameters
Sensor gain setting, Electrical shutter exposure period, ALC and AWB reference value
• Auto electrical shutter control (AES), auto gain control (AGC) and auto white balance (AWB) circuit
• Flickerless auto luminance control (ALC=AES+AGC) and auto flicker detection circuit for AC 50Hz / 60Hz fluorescent light
• Automatically blemish correction
• Vertical and Horizontal flip mode
TOSHIBA is continually working to improve the quality and the reliability of its products. Nevertheless, semiconductor devices in general can malfunction or
●
jail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to
observe standards of safety, and to avoid situations in which a malfunction or failure of a TOSHIBA product could cause loss of human life, bodily injury or
damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating range as set forth in the most
recent products specif ications. Also, please keep in mind the precautions and conditions setf orth in the TOSHIBA Semiconductor Reliability Handbook.
The products described in this document are subject tof oreign exchange andf oreign trade control laws.
●
●
The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA
CORPORATION for any infringements of intellectual property or other rights of the third parties which may result from its use. No license is granted by
implication or otherwise under any intellectual property or other rights of TOSHIBA CORPORATION or others.
The inf ormation contained herein is subject to change without notice.
●
04/01/05
1/27