SMF5.0A-AU SERIES
SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR
Unit:inch(mm)
SOD-123FL
POWER
200 Watt
5 to 70 Volt
VOLTAGE
FEATURES
• For surface mounted applications in order to optimize board space.
• Ultra thin profile package for space constrained utilization
• Package suitable for Automated Handling
• Low inductance
0.115(2.90)
0.106(2.70)
0.044(1.10)
0.035(0.90)
• High temperature soldering : 260OC/10 seconds at terminals
• ESD IEC-61000-4-2 Air + 30kV, Contact + 30kV
• AEC-Q101 qualified
0.008(0.20)
0.004(0.10)
0.145(3.70)
0.137(3.50)
• Lead free in compliance with EU RoHS 2.0
• Green molding compound as per IEC 61249 standard
0.030(0.75)
0.017(0.45)
MECHANICAL DATA
• Case: SOD-123FL, Plastic
• Terminals: Solderable per MIL-STD-750, Method 2026
• Polarity: Color band denotes cathode end
• Weight: 0.0006 ounces, 0.0173 grams
• Standrad Packaging: 8mm tape (EIA-481)
1
2
Cathode
Anode
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (TA=25oC unless otherwise noted)
PARAMETER
SYMBOL
VALUE
200
UNITS
W
Peak Pulse Power Dissipation on TA = 25OC (Notes 1,2,5, Fig.1)
P
PPM
FSM
PPM
Peak Forward Surge Current per (Notes 3)
I
20
see Table 1
1
A
Peak Pulse Current on tp=10/1000μs waveform (Notes 1) Fig.2
Steady State Power Dissipation (Notes 4)
I
A
PM(AV)
W
kV
OC
OC
ESD IEC-61000-4-2 (Air)
ESD IEC-61000-4-2 (Contact)
+30
+30
VESD
Operating Junction and Storage Temperature Range
Typical thermal resistance
TJ,TSTG
-55 to +150
180
RθJA
NOTES :
1.Non-repetitive current pulse, per Fig.3 and derated above TA=25OC per Fig.2 .
2.Mounted on 5mm2 copper pads to each terminal.
3.8.3ms single half sine-wave, or equivalent square wave, duty cycle = 4 pulses per minutes maximum.
4.Lead temperature at 75OC =TL .
5.Peak pulse power waveform is tp=10/1000μs.
6.A transient suppressor is selected according to the working peak reverse voltage(VRWM), which should be
equal to or greater than the DC or continuous peak operating voltage level.
PAGE . 1
August 15,2018-REV.11