preliminary Data Sheet
Rev.0.9
11.06.2013
4GB DDR3L – SDRAM ECC SO-UDIMM
Features:
204 Pin ECC SO-UDIMM
.
204-pin 72-bit DDR3 Small Outline, Dual-In-Line Double
Data Rate synchronous DRAM Module
Module organization: single rank 512M x 72
VDD = 1.35V and 1.5V
SLN04G72F1BA1HY-xxRT
4GByte in FBGA Technology
RoHS compliant
.
.
.
.
.
.
VDDQ 1.35V and 1.5V
1.5V I/O ( SSTL_15 compatible)
Fly-by-bus with termination for C/A & CLK bus
On-board I2C temperature sensor with integrated serial
presence-detect (SPD) EEPROM
Gold-contact pad
Options:
.
Data Rate / Latency
DDR3 1333 MT/s CL9
DDR3 1600 MT/s CL11
Marking
-CC
.
.
This module is fully pin and functional compatible to the
JEDEC EP3-12800 DDR3 SDRAM 72bit-SO-DIMM design
spec. and JEDEC- Standard MO-268. (see www.jedec.org)
The pcb and all components are manufactured according
-DC
.
.
Module Density
4GByte with 9 dies and 1 rank
to the RoHS compliance specification
[EU Directive 2002/95/EC Restriction of Hazardous
Substances (RoHS)]
.
Standard Grade
(TA)
(TC)
0°C to 70°C
0°C to 85°C
.
DDR3L - SDRAM component Hynix
H5TC4G83AFR-PBA
.
.
.
512Mx8 DDR3 SDRAM in PG-TFBGA-78 package
8-bit prefetch architecture
Programmable CAS Latency, CAS Write Latency, Additive
Latency, Burst Length and Burst Type.
On-Die-Termination (ODT) and Dynamic ODT for
improved signal integrity.
*) The refresh rate has to be doubled when 85°C<TC<95°C
.
Environmental Requirements:
.
.
.
Refresh, Self Refresh and Power Down Modes.
ZQ Calibration for output driver and ODT.
System Level Timing Calibration Support via Write
Leveling and Multi Purpose Register (MPR) Read Pattern.
.
Operating temperature (ambient)
Standard Grade
0°C to 70°C
.
.
.
.
.
Operating Humidity
10% to 90% relative humidity, noncondensing
Operating Pressure
105 to 69 kPa (up to 10000 ft.)
Storage Temperature
-55°C to 100°C
Storage Humidity
5% to 95% relative humidity, noncondensing
Storage Pressure
Figure: mechanical dimensions1
1682 PSI (up to 5000 ft.) at 50°C
1
if no tolerances specified ± 0.15mm
Swissbit AG
Industriestrasse 4
CH – 9552 Bronschhofen
Fon: +41 (0) 71 913 03 03
Fax: +41 (0) 71 913 03 15
www.swissbit.com
eMail: info@swissbit.com
Page 1
of 17