SLA7052M
UNIPOLAR STEPPER-MOTOR
TRANSLATOR/PWM DRIVER
Combining low-power CMOS logic with high-current, high-voltage
power FET outputs, the SLA7052M translator/driver provides complete
control and drive for a two-phase unipolar stepper motor with internal
fixed off time, pulse-width modulation (PWM) control of the output
current in a power multi-chip module (PMCM™).
The CMOS logic section provides the sequencing logic, direction,
full/half-step control, synchronous/asynchronous PWM operation, and
a “sleep” function. The minimum CLOCK input is an ideal fit for ap-
plications where a complex μP is unavailable or overburdened. TTL or
LSTTL may require the use of appropriate pull-up resistors to ensure a
proper input-logic high. For PWM current control, the maximum out-
put current is determined by the user’s selection of a reference voltage
and sensing resistor. The NMOS outputs are capable of sinking up to
3 A and withstanding 46 V in the off state. Ground-clamp and flyback
diodes provide protection against inductive transients. Special power-
up sequencing is not required.
Full-step (2 phase) and half-step operation are externally selectable.
Two-phase drive energizes two adjacent phases in each detent position
(AB-BC-CD-DA). This sequence mode offers an improved torque-
speed product, greater detent torque, and is less susceptable to motor
resonance. Half-step excitation alternates between the one-phase and
two-phase modes (A-AB-B-BC-C-CD D-DA), providing an eight-step
sequence.
The SLA7052M is supplied in an 18-pin single in-line power-tab
package with leads formed for vertical mounting (suffix LF871) or
horizontal mounting (suffix LF872). The tab is at ground potential and
needs no insulation. For high-current or high-frequency applications,
external heat sinking may be required. This device is rated for continu-
ous operation between -20°C and +85°C.
ABSOLUTE MAXIMUM RATINGS
Driver Supply Voltage, VBB ................. 46 V
Load Supply Voltage, VM ................... 46 V
Output Current, IO ........................... 3.0 A*
Logic Supply Voltage, VDD ................ 7.0 V
Logic Input Voltage Range,
VI .......................... -0.3 V to VDD+ 0.3 V
Sense Voltage, VS ......................... ±2.0 V†
Reference Input Voltage Range,
VREF........................ -0.3 V to VDD+ 0.3 V
Package Power Dissipation,
PD ....................................... See Graph
Junction Temperature, TJ .............. +150°C
Operating Temperature Range,
FEATURES
3 A Output Rating
Internal Sequencer for Full or Half-Step Operation
PWM Constant-Current Motor Drive
Cost-Effective, Multi-Chip Solution
100 V, Avalanche-Rated NMOS
Low rDS(on) NMOS Outputs (150 m typical)
Advanced, Improved Body Diodes
Half-Step and Full-Step Unipolar Drive
Inputs Compatible with 3.3 V or 5 V Control Signals
Sleep Mode
TA .................................. -20°C to +85°C
Storage Temperature Range,
TS ............................... -30°C to +150°C
* Output current rating may be limited by duty cycle,
ambient temperature, and heat sinking. Under any set of
conditions, do not exceed the specified current rating or
junction temperature.
† Internal filtering provides protection against transients
during the first 1 μs of the current-sense pulse.
Internal Clamp Diodes
Always order by complete part number, e.g., SLA7052MLF871 .
Sanken Power Devices
from Allegro MicroSystems