Skylla TG Series
T H R E E S T E P B AT T E R Y C H A R G E R
FEATURES
• 720W - 2400W
• 24V and 48V Systems
• Three Step Charger
• Temp Compensation
• On 24V models 2 separate outputs
• Charge 2 battery banks
• Corrosion Resistant
SPECIFICATIONS
INPUT
PROTECTION
Short circuit
1ph: 185-264Vac
3ph: 320-450Vac 180-400Vdc
Yes. output short circuit protection
Yes, battery reverse polarity detection
Yes, battery voltage too high
Input voltage
Battery connection
Battery voltage
Over temperature
STANDARDS
Safety
Input frequency
Power factor
OUTPUT
45 - 65Hz
1.0
Yes, temperature too high protection
Optimum absorption charge and float charge voltages
for Flooded Lead-acid, Gel-Cell or AGM batteries.
Selectable by dip switch
28.5Vdc and 57Vdc
See selection table.
EN60335-1, EN60335-2-29.
EN55014, EN61000-3-2
Battery Charging
Emission
Absorption Charge voltage
Float Charge voltage
Immunity
EN55014-2, EN61000-3-3
AS/NZS CISPR11: Group 1, Class A.
26.5Vdc and 53Vdc
See selection table.
C-tick
ENVIRONMENTAL
Operating temperature
Two outputs to charge 2 battery banks (24V models
only). The TG chargers feature 2 isolated outputs. The
second output is limited to approx 4A and with a
slightly lower output voltage. It is intended to top up a
starter battery.
-20°C to 60°C.
Full load up to 40C ambient, Output will reduce to
approximately 80% of nominal at 50C and 60% of
nominal at 60C
Two Outputs
Derating
See selection table.
Cooling
Temperature and current controlled fan.
95% max (non condensing).
Total output ammeter
Charge characteristic
Yes.
Humidity
Accurately controls the charging in 3 steps. Charges
more rapidly than other processes
MECHANICAL
AC connection
Battery connection
Protection category
Battery temperature sensor supplied. When
connected charge voltage will automatically decrease
with increasing battery temperature.
Screw-clamp 2-5mm² (AWG 6)
Temperature sensor
M8 studs
IP21.
The BMV 600S battery monitor features an advanced
control and measuring system for battery voltage and
charge/discharge current. The battery monitor
selectively displays battery voltage, current,
consumed AH or time to go.
Aluminum epoxy powder coated cases (blue RAL 5012),
Stainless steel fixings
24/30TG-24/50TG: 365x250x147mm, 5.5Kg
24/50TG 3Phase: 365x250x257mm, 13Kg
24/80TG: 365x250x257mm, 10Kg
24/100TG: 365x250x257mm, 10Kg
24/100TG 3Phase: 515x260x265mm, 23Kg
48/25TG: 365x250x147mm, 5.5Kg
Material & colour
Battery Monitor
Skylla Control
The Skylla Control allows you to alter the charge
current and see the system status
Size & Weight
Charger switch
Remote alarm
A remote on-off switch
Potential free contacts 60V / 1A (1 x NO & 1 x NC)
48/50TG: 365x250x257mm, 10Kg
APPLICATION
Doc. No. Skylla Rev.B 23-11-15