SGM2575
5.5V, 2A, 34mΩ RON Load Switch with
Reverse Current Protection
GENERAL DESCRIPTION
FEATURES
The SGM2575 is a single load switch with reverse
current protection and controlled turn-on. The device
can operate from 1V to 5.5V single supply and has the
ability to drive up to 2A continuous current.
● Input Voltage Range: 1V to 5.5V
● Maximum Continuous Current: 2A
● Low On-Resistance
RON = 34mΩ at VIN = 5V
RON = 34mΩ at VIN = 3.3V
The device contains a 34mΩ low RON N-MOSFET
controlled by the ON pin. When the power supply is
turned on for the first time, a smart pull-down resistor is
used to float the ON pin until the system is stable. Once
the ON pin reaches a high voltage (> VIH), the pull-down
resistor is disconnected, then the standby current is very
low and power loss can be reduced. The small package
and low RON make the device very suitable for space
limited, battery powered applications.
● Low Shutdown Current: 90nA (TYP)
● Reverse Current Protection When Disabled
● Low Threshold 1.8V GPIO Control Input
● Bidirectional Power Supply for Power Zone
Application
● Rise Time:
SGM2575A/SGM2575AD: 60μs (TYP)
SGM2575BD: 1600μs (TYP)
● Quick Output Discharge
The device supports a wide input voltage range, which
is suitable for many different voltage rails. The rise time
is used to avoid inrush current. The SGM2575AD/
SGM2575BD offer the quick output discharge function
in disable status.
(SGM2575AD/SGM2575BD Only)
● Available in a Green WLCSP-0.8×0.8-4B Package
APPLICATIONS
The SGM2575 is available in a Green WLCSP-0.8×0.8-4B
package.
Mobile Phone
Ultrabook
Tablet PC
Digital Camera
Wearable Technology
Solid State Drive
TYPICAL APPLICATION
VIN
VIN
ON
VOUT
CIN
SGM2575
COUT
ROUT
On
GND
Off
Figure 1. Typical Application Circuit
SG Micro Corp
www.sg-micro.com
FEBRUARY 2022 – REV. A. 2