SGM2578A
5.5V, 2A, 30mΩ RON Load Switch with
Reverse Current Protection
GENERAL DESCRIPTION
FEATURES
The SGM2578A is a single load switch with reverse
current protection function. The device can operate
from 1V to 5.5V single supply and has the ability to
drive up to 2A continuous current.
● Input Voltage Range: 1V to 5.5V
● Low On-Resistance
RON = 29mΩ at VIN = 4.35V
RON = 30mΩ at VIN = 3.3V
RON = 36mΩ at VIN = 1.0V
The device contains a 30mΩ low RON N-MOSFET
controlled by the ON pin. If the power supply is turned
on for the first time, a smart pull-down resistor is used
to float the ON pin until the system is stable. Once the
ON pin reaches a high voltage (> VIH), the pull-down
resistor is disconnected, then the standby current is very
low and power loss can be reduced. The small package
and low RON make the device very suitable for space
limited, battery powered applications.
● Low Shutdown Current: 90nA (TYP)
● Maximum Continuous Current: 2A
● Reverse Current Protection When Disabled
● Low Threshold 1.8V GPIO Control Input
● Bidirectional Power Supply for Power Zone
Application
● Rise Time:
SGM2578AAD: 200μs (TYP)
SGM2578ABD: 5000μs (TYP)
● Quick Output Discharge
The device supports a wide input voltage range, which
is suitable for different voltage rails. The rise time is
used to avoid inrush current. The SGM2578A offers the
quick output discharge function in disable status.
● Available in a Green WLCSP-0.9×0.9-4B-A Package
APPLICATIONS
The SGM2578A is available in a Green WLCSP-
0.9×0.9-4B-A package.
Mobile Phone
Ultrabook
Tablet PC
Digital Camera
Wearable Technology
Solid State Drive
TYPICAL APPLICATION
VIN
VIN
ON
VOUT
CIN
SGM2578A
COUT
ROUT
On
GND
Off
Figure 1. Typical Application Circuit
SG Micro Corp
www.sg-micro.com
MARCH2023–REV. A.2