SGM2567A
5.5V, 4A, 15mΩ RON Load Switch with
Reverse Current Protection
GENERAL DESCRIPTION
FEATURES
The SGM2567A is a single load switch with reverse
current protection function. The device can operate
from 2.2V to 5.5V single supply and has the ability to
drive up to 4A continuous current.
● Input Voltage Range: 2.2V to 5.5V
● Maximum Continuous Current: 4A
● Low On-Resistance
RON = 15mΩ at VIN = 5V
RON = 15mΩ at VIN = 3.3V
The device contains a 15mΩ low RON N-MOSFET
controlled by the ON pin. When the power supply is
turned on for the first time, a smart pull-down resistor is
used to float the ON pin until the system is stable. Once
the ON pin reaches a high voltage (> VIH), the pull-down
resistor is disconnected, then the standby current is very
low and power loss can be reduced. The small package
and low RON make the device very suitable for space
limited, battery powered applications.
● Low Shutdown Current: 0.31μA (TYP)
● Reverse Current Protection When Disabled
● Low Threshold 1.8V GPIO Control Input
● Bidirectional Power Supply for Power Zone
Application
● Quick Output Discharge
● Internal Fixed Slew Rate to Avoid Inrush Current
● Over-Temperature Protection
● Available in a Green WLCSP-1.45×0.95-6B Package
The device supports a wide input voltage range, which
is suitable for many different voltage rails. The rise time
is used to avoid inrush current. The SGM2567A offers
the quick output discharge function in disable status.
APPLICATIONS
Smartphone
Notebook and Tablet Computers
Solid State Drive (SSD)
The SGM2567A is available in a Green WLCSP-
1.45×0.95-6B package.
Set-Top Boxes and Residential Gateways
Portable and Handheld Devices
TYPICAL APPLICATION
VIN
VIN
ON
VOUT
CIN
SGM2567A
COUT
ROUT
On
GND
Off
Figure 1. Typical Application Circuit
SG Micro Corp
MAY 2022–REV. A.1
www.sg-micro.com