5秒后页面跳转
捷配首页

Datasheet > SC16C852LIBS,115
SC16C852LIBS,115 PDF预览

SC16C852LIBS,115

更新时间： 2024-02-05 19:53:53
品牌 Logo 应用领域
恩智浦 - NXP 通信时钟数据传输先进先出芯片外围集成电路
页数 文件大小 规格书
64页 405K
描述
SC16C852L - 1.8 V dual UART, 5 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA) and 16 mode or 68 mode bus interface QFN 32-Pin

阅读下载

中文翻译

获取价格

SC16C852LIBS,115 技术参数

是否Rohs认证： 符合生命周期：Obsolete
零件包装代码：QFN包装说明：5 X 5 MM, 0.85 MM HEIGHT, ROHS COMPLIANT, PLASTIC, MO-220, SOT-617-1, HVQFN-32
针数：32Reach Compliance Code：unknown
HTS代码：8542.31.00.01风险等级：5.82
地址总线宽度：3边界扫描：NO
最大时钟频率：80 MHz通信协议：ASYNC, BIT
数据编码/解码方法：NRZ最大数据传输速率：0.625 MBps
外部数据总线宽度：8JESD-30 代码：S-PQCC-N32
JESD-609代码：e4长度：5 mm
低功率模式：YES湿度敏感等级：1
串行 I/O 数：2端子数量：32
最高工作温度：85 °C最低工作温度：-40 °C
封装主体材料：PLASTIC/EPOXY封装代码：HVQCCN
封装等效代码：LCC32,.2SQ,20封装形状：SQUARE
封装形式：CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE峰值回流温度（摄氏度）：260
电源：1.8 V认证状态：Not Qualified
座面最大高度：1 mm子类别：Serial IO/Communication Controllers
最大供电电压：1.95 V最小供电电压：1.65 V
标称供电电压：1.8 V表面贴装：YES
技术：CMOS温度等级：INDUSTRIAL
端子面层：Nickel/Palladium/Gold (Ni/Pd/Au)端子形式：NO LEAD
端子节距：0.5 mm端子位置：QUAD
处于峰值回流温度下的最长时间：30宽度：5 mm
uPs/uCs/外围集成电路类型：SERIAL IO/COMMUNICATION CONTROLLER, SERIALBase Number Matches：1

SC16C852LIBS,115 数据手册

 浏览型号SC16C852LIBS,115的Datasheet PDF文件第2页浏览型号SC16C852LIBS,115的Datasheet PDF文件第3页浏览型号SC16C852LIBS,115的Datasheet PDF文件第4页浏览型号SC16C852LIBS,115的Datasheet PDF文件第5页浏览型号SC16C852LIBS,115的Datasheet PDF文件第6页浏览型号SC16C852LIBS,115的Datasheet PDF文件第7页 
SC16C852L  
1.8 V dual UART, 5 Mbit/s (max.) with 128-byte FIFOs,  
infrared (IrDA) and 16 mode or 68 mode bus interface  
Rev. 4 — 1 February 2011  
Product data sheet  
1. General description  
The SC16C852L is a 1.8 V, low power, dual channel Universal Asynchronous Receiver  
and Transmitter (UART) used for serial data communications. Its principal function is to  
convert parallel data into serial data and vice versa. The UART can handle serial data  
rates up to 5 Mbit/s. The SC16C852L is pin compatible with the SC16C652B. SC16C852L  
can be programmed to operate in extended mode (see Section 6.2) where additional  
advanced UART features are available. The SC16C852L UART provides enhanced  
UART functions with 128-byte FIFOs, modem control interface, DMA mode data transfer,  
and IrDA encoder/decoder. The DMA mode data transfer is controlled by the FIFO trigger  
levels and the TXRDYx and RXRDYx signals. On-board status registers provide the user  
with error indications and operational status. System interrupts and modem control  
features may be tailored by software to meet specific user requirements. An internal  
loopback capability allows on-board diagnostics. Independent programmable baud rate  
generators are provided to select transmit and receive baud rates.  
The SC16C852L with Intel (16 mode) or Motorola (68 mode) bus host interface operates  
at 1.8 V and is available in plastic LQFP48, TFBGA36 and very small (Micro-UART)  
HVQFN32 packages.  
2. Features and benefits  
Dual channel high performance UART  
Intel or Motorola bus interface selectable using 16/68 pin  
1.8 V operation  
Up to 5 Mbit/s data rate  
128-byte transmit FIFO to reduce the bandwidth requirement of the external CPU  
128-byte receive FIFO with error flags to reduce the bandwidth requirement of the  
external CPU  
128 programmable Receive and Transmit FIFO interrupt trigger levels  
128 Receive and Transmit FIFO reporting levels (level counters)  
Automatic software (Xon/Xoff) and hardware (RTS/CTS or DTR/DSR) flow control  
Industrial temperature range (40 C to +85 C)  
Pin, function, and software compatible to SC16C652B in LQFP48 package  
128 hardware and software trigger levels  
Automatic 9-bit mode (RS-485) address detection  
Automatic RS-485 driver turn-around with programmable delay  
Dual channel concurrent write  
UART software reset  
 
 
1234567...64

中文翻译

下载PDF

SC16C852LIBS,115 替代型号

型号 品牌 替代类型 描述 数据表
SC16C852LIBS,128 NXP

完全替代

 SC16C852L - 1.8 V dual UART, 5 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA) and 16 m

与SC16C852LIBS,115相关器件

型号 品牌 获取价格 描述 数据表
SC16C852LIBS,128 NXP

获取价格

 		SC16C852L - 1.8 V dual UART, 5 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA) and 16 m
SC16C852LIET NXP

获取价格

 		1.8 V dual UART, 5 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA) and 16 mode or 68 mo
SC16C852LIET,115 NXP

获取价格

 		SC16C852L - 1.8 V dual UART, 5 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA) and 16 m
SC16C852LIET,118 NXP

获取价格

 		SC16C852L - 1.8 V dual UART, 5 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA) and 16 m
SC16C852LIET,151 NXP

获取价格

 		SC16C852L - 1.8 V dual UART, 5 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA) and 16 m
SC16C852LIET,157 NXP

获取价格

 		SC16C852L - 1.8 V dual UART, 5 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA) and 16 m
SC16C852SV NXP

获取价格

 		1.8 V dual UART, 20 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA), and XScale VLIO bu
SC16C852SVIET NXP

获取价格

 		1.8 V dual UART, 20 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA), and XScale VLIO bu
SC16C852SVIET,115 NXP

获取价格

 		SC16C852SV - 1.8 V dual UART, 20 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA), and X
SC16C852SVIET,157 NXP

获取价格

 		SC16C852SV - 1.8 V dual UART, 20 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA), and X

与SC16C852LIBS,115相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证