SA5.0 THRU SA170CA
GLASS PASSIVATED JUNCTION TRANSIENT VOLTAGE SUPPRESSOR
VOLTAGE - 5.0 TO 170 Volts
500 Watt Peak Pulse Power
FEATURES
l
Plastic package has Underwriters Laboratory
Flammability Classification 94V-O
DO-15
l
l
Glass passivated chip junction
500W Peak Pulse Power capability on
10/1000 £gS waveform
l
l
l
l
Excellent clamping capability
Repetition rate(duty cycle): 0.01%
Low incremental surge resistance
Fast response time: typically less
than 1.0 ps from 0 volts to BV for unidirectional
and 5.0ns for bidirectional types
l
l
£g
Typical ID less than 1 A above 10V
High temperature soldering guaranteed:
300 ¢J/10 seconds/.375”,(9.5mm) lead
length/5lbs., (2.3kg) tension
MECHANICAL DATA
Case: JEDEC DO-15 molded plastic over passivated junction
Terminals: Plated Axial leads, solderable per MIL-STD-750, Method 2026
Polarity: Color band denoteds positive end(cathode) except Bidirectionals
Mounting Position: Any
Weight: 0.015 ounce, 0.4 gram
DEVICES FOR BIPOLAR APPLICATIONS
For Bidirectional use C or CA Suffix for types
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND CHARACTERISTICS
Ratings at 25 ¢J ambient temperature unless otherwise specified.
RATING
SYMBOL
PPPM
VALUE
Minimum 500
UNITS
Watts
£g
Peak Pulse Power Dissipation on 10/1000 S waveform
(Note 1, FIG.1)
Peak Pulse Current of on 10/1000 £gS waveform
(Note 1, FIG.3)
Steady State Power Dissipation at TL=75 ¢J Lead
IPPM
PM(AV)
IFSM
SEE TABLE 1
Amps
Watts
Amps
1.0
70
Lengths .375”,(9.5mm) (Note 2)
Peak Forward Surge Current, 8.3ms Single Half Sine-Wave
Superimposed on Rated Load, Unidirectional only
(JECED Method) (Note 3)
Operating Junction and Storage Temperature Range
TJ,TSTG
-65 to +175
¢J
NOTES:
¢J
1.Non-repetitive current pulse, per Fig. 3 and derated above TA=25 per Fig. 2.
2.Mounted on Copper Leaf area of 1.57in2(40mm2) PER Figure 5.
3.8.3ms single half sine-wave or equivalent square wave, Duty cycle= 4 pulses per minute maximum.