SA5.0 thru SA170CA
GGLLAASSSS PPAASSSSIIVVAATTEEDD JJUUNNCCTTIIOONN TTRRAANN--
SSIIEENNTT VVOOLLTTAAGGEE SSUUPPPPRREESSSSOORR
CCHHEENNGG--YYII
ELECTRONIC
VOLTAGE 6.8 to 144 VOLTS
400 WATT PEAK POWER
1.0 WATTS STEADY STATE
DO-15
FEATURES
Plastic package has Underwrites Laboratory
Flammability Classification 94V-O
Glass passivated chip junction
500W Peak Pulse Power capability
on 10/1000 s waveform
Excellent clamping capability
Repetition rate (duty cycle):0.01%
Low incremental surge resistance
Fast response time: typically less than 1.0 ps
from 0 volts to BV for unidirctional and 5.0ns
for bidirctional types
Typical ID less than 1 A above 10V
High tempreature soldering guaranteed:
0
300 C/10 seconds .375", (9.5mm)
lead length/51bs.,(2.3kg) tension
MECHANICAL DATA
Case:JEDEC DO-15 Molded plastic over passivated junction
Terminals:Plated Axial leads, solderable per MIL-STD-750, Method 2026
Polarity:Color band denotes positive end (cathode) except Bidirectionals types
Mounting Position
Weight:0.015 ounce, 0.4 gram
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
0
Ratings at 25 C ambient temperature unless otherwise specified.
RATINGS
SYMBOL
VALUE
UNITS
Watts
Amps
Peak Pulse Power Dissipation on 10/1000 s waveform (NOTE 1,2,Fig.1)
Peak Pulse Current of on 10/1000 s waveform (NOTE 1,Fig.3)
PPPM
Minimum 5000
SEE TABLE 1
IPPM
0
Steady Power Dissipation at TL=75 C
PM(AV0
1.0
Watts
Lead Lengths .375",(9.5mm)(NOTE 2)
Peak Forward Surge Current, 8.3ms Single Half Sine-Wave Super-
imposed on Rated Load, unidirrctional only (JEDEC Method)(NOTE 3)
Amps
IFSM
70.0
0
Operating Junction and Storage Temperature Range
TJ, TSTG
-65 to + 175
C
0
Notes: 1. Non-repetitive current pulse, per Fig.3 and derated above TA=25 C per Fig.2
2
2
2. Measured on copper Leaf area of 1.57 in (40mm ) per Figure 5
3. 8.3ms single half sine-wave or equivalent square wave, Duty Cycle=4 pulses per minutes maximum.