®
RTQ2942-QA
42VIN, 2.5A, Asynchronous Step-Down Converter with Low
Quiescent Current
General Description
Features
AEC-Q100 Grade 1 Qualified
The RTQ2942 is a 2.5A, high-efficiency, peak current mode
control asynchronous step-down converter which is
optimized for automotive applications. The device operates
with input voltages from 4V to 42V and is protected from
load dump transients up to 45V, eases input surge
protection design. The device can program the output
voltage between 0.8V to VIN. The low quiescent current
design with the integrated low RDS(ON) of high-side
MOSFET achieves high efficiency over the wide load range.
The peak current mode control with simple external
compensation allows the use of small inductors and
results in fast transient response and good loop stability.
FMEA Compliant Pinout
Wide Input Voltage Range
4.5V to 42V
4V to 42V (Soft-start is finished)
Wide Output Voltage Range : 0.8V to VIN
0.8V 1.5% Reference Accuracy
Peak Current Mode Control
Integrated 150mΩ High-Side MOSFET
Low Quiescent Current : 90μA
Low Shutdown Current : 1.3μA
Adjustable Switching : 100kHz to 2.5MHz
Synchronizable Switching : 300kHz to 2.2MHz
Power Saving Mode (PSM) at Light Load
Built-In Spread-Spectrum Frequency Modulation
Low Dropout at Light Loads with Integrated Boot
Recharge FET
The wide switching frequency of 100kHz to 2500kHz allows
for efficiency and size optimization when selecting the
output filter components. The ultra-low minimum on-time
enables constant-frequency operation even at very high
step-down ratios. For switching noise sensitive
applications, it can be externally synchronized from
300kHz to 2200kHz. The build-in spread-spectrum
frequency modulation further helping systems designers
with better EMC management.
Externally Adjustable Soft-Start by Part Number
Option
Power Good Indication by Part Number Option
Enable Control
Adjustable UVLO Voltage and Hysteresis
Adjacent Pin-Short Protection
Built-In UVLO, UVP, OVP, OCP, OTP
The RTQ2942 provides complete protection functions such
as input under-voltage lockout, output under-voltage
protection, output over-voltage protection, over-current
protection, and thermal shutdown. Cycle-by-cycle current
limit provides protection against shorted outputs, and soft-
start eliminates input current surge during start-up. The
RTQ2942 is available in WDFN-10SL 3x3 and SOP-8
(Exposed pad) packages.
Applications
Automotive, Communications and Industrial 12V and 24V
Power Systems
IndustrialAutomation and Motor Control
Vehicle Accessories : GPS, Entertainment
Simplified Application Circuit
RTQ2942GSP
C
BOOT
RTQ2942GQW
C
BOOT
V
IN
VIN
BOOT
V
IN
VIN
BOOT
L1
L1
C
IN
V
SW
OUT
C
SW
V
OUT
IN
D1
C
OUT
D1
R
R
FB1
C
OUT
EN
Enable Signal
PGOOD
R
R
FB1
EN
Enable Signal
FB
FB
PGOOD
R
RT
FB2
C
COMP1
FB2
R
COMP
RT/SYNC
COMP
COMP
C
COMP1
C
R
COMP
SS/TR
R
RT
C
COMP2
C
SS
RT/SYNC
PAD
COMP2
GND
GND
PAD
Copyright 2021 Richtek Technology Corporation. All rights reserved.
©
is a registered trademark of Richtek Technology Corporation.
DSQ2942-QA-01 March 2021
www.richtek.com
1