5秒后页面跳转
RP504K101D-E2 PDF预览

RP504K101D-E2

更新时间: 2024-11-13 19:09:51
品牌 Logo 应用领域
理光 - RICOH 开关光电二极管
页数 文件大小 规格书
29页 795K
描述
Switching Controller, Voltage-mode, 0.9A, 2550kHz Switching Freq-Max, CMOS, PDSO6, 1.20 X 1.60 MM, HALOGEN FREE AND ROHS COMPLIANT, DFN-6

RP504K101D-E2 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Active零件包装代码:DFN
包装说明:VSON,针数:6
Reach Compliance Code:unknownECCN代码:EAR99
HTS代码:8542.39.00.01风险等级:5.61
模拟集成电路 - 其他类型:SWITCHING CONTROLLER控制模式:VOLTAGE-MODE
控制技术:PULSE WIDTH MODULATION最大输入电压:5.5 V
最小输入电压:2.3 V标称输入电压:3.6 V
JESD-30 代码:R-PDSO-N6JESD-609代码:e4
长度:1.6 mm湿度敏感等级:1
功能数量:1端子数量:6
最高工作温度:85 °C最低工作温度:-40 °C
最大输出电流:0.9 A标称输出电压:1 V
封装主体材料:PLASTIC/EPOXY封装代码:VSON
封装形状:RECTANGULAR封装形式:SMALL OUTLINE, VERY THIN PROFILE
峰值回流温度(摄氏度):NOT SPECIFIED认证状态:Not Qualified
座面最大高度:0.4 mm表面贴装:YES
切换器配置:BOOST最大切换频率:2550 kHz
技术:CMOS温度等级:INDUSTRIAL
端子面层:Gold (Au)端子形式:NO LEAD
端子节距:0.5 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED宽度:1.2 mm
Base Number Matches:1

RP504K101D-E2 数据手册

 浏览型号RP504K101D-E2的Datasheet PDF文件第2页浏览型号RP504K101D-E2的Datasheet PDF文件第3页浏览型号RP504K101D-E2的Datasheet PDF文件第4页浏览型号RP504K101D-E2的Datasheet PDF文件第5页浏览型号RP504K101D-E2的Datasheet PDF文件第6页浏览型号RP504K101D-E2的Datasheet PDF文件第7页 
RP504x SERIES  
600mAStep-down DC/DC Converter with Synchronous Rectifier  
NO.EA-259-130520  
OUTLINE  
The RP504x Series are low supply current CMOS-based 600mAstep-down DC/DC Converters with  
synchronous rectifier. Each of these ICs consists of an oscillator, a reference voltage unit, an error amplifier, a  
switching control circuit, a mode control circuit(Ver.A, D), a soft-start circuit, a "latch type" protection circuit, an  
under voltage lockout (UVLO) circuit, and switching transistors. A low ripple, high efficiency synchronous rectifier  
step-down DC/DC converter can be easily composed of this IC with only an inductor and capacitors. Since  
packages are SOT-23-5, DFN1616-6B, DFN(PLP)1216-6F, high density mounting on boards is possible.  
As protection circuits, the RP504x Series contain a current limit circuit which limits the Lx peak current in each  
clock cycle, and a latch type protection circuit which latches the built-in driver to the OFF state if the load current  
exceeds the limit value or the output short continues for a specified time (the protection delay time). The latch  
protective circuit can be released by once putting the IC into the standby mode with the CE pin and then into the  
active mode, or, by turning the power off and back on. Setting the supply voltage lower than the UVLO detector  
threshold can also release the latch protective circuit.  
In terms of the output voltage, since the feedback resistances are built-in, the voltage is fixed internally. 0.1V  
step output can be set by laser-trim and 1.5% or 18mV tolerance depending on the output voltage is  
guaranteed. By inputting a signal to a MODE pin, the RP504x Series can be switched between PWM/VFM auto  
switching control and Forced PWM control. PWM/VFM auto switching control switches to high-efficiency VFM  
mode in low output current. Forced PWM control switches to fixed-frequency Forced PWM mode for reducing  
noise in low output current.  
)This is an approximate value, because output current depends on conditions and external parts.  
FEATURES  
Supply Current...................................................... Typ. 25A(at VFM mode, at no load)  
Standby Current.................................................... Max. 5A  
Input Voltage Range ............................................. 2.3V to 5.5V (VOUT1.0V)  
Output Voltage Range........................................... 0.8V to 3.3V (With a 0.1V step)  
Output Voltage Accuracy....................................... 1.5% (VOUT1.2V), 18mV (VOUT<1.2V)  
Temperature-Drift Coefficient of Output Voltage... Typ. 40ppm/C  
Oscillator Frequency............................................. Typ. 2.25MHz  
Oscillator Maximum Duty Cycle............................ Min. 100%  
Built-in Driver ON Resistance ............................... Typ. Pch. 0.34Nch. 0.43(VIN=3.6V)  
UVLO Detector Threshold..................................... Typ. 2.0V  
Soft Start Time....................................................... Typ. 0.15ms  
LX Current Limit..................................................... Typ. 900mA  
Latch type Protection Circuit................................. Typ. 1.5ms  
Auto discharge function ........................................ Only for D Version  
Two choices of Switching Mode............................ DFN1616-6B and DFN(PLP)1216-6F are available in  
adjustable switching control options from PWM/VFM auto switching type or Forced PWM type by using  
MODE pin. SOT-23-5 is available in fixed switching control options: PWM/VFM auto switching type for B  
version or Forced PWM type for C version.  
Packages .............................................................. SOT-23-5, DFN1616-6B, DFN(PLP)1216-6F  
1

与RP504K101D-E2相关器件

型号 品牌 获取价格 描述 数据表
RP504K101D-TR RICOH

获取价格

Switching Controller
RP504K111AD-TR RICOH

获取价格

DC-DC Regulated Power Supply Module, 1 Output, Hybrid, HALOGEN FREE AND ROHS COMPLIANT, DF
RP504K111A-E2 RICOH

获取价格

Switching Controller, Voltage-mode, 0.9A, 2550kHz Switching Freq-Max, CMOS, PDSO6, 1.20 X
RP504K111A-TR RICOH

获取价格

Switching Controller
RP504K111D-E2 RICOH

获取价格

Switching Controller, Voltage-mode, 0.9A, 2550kHz Switching Freq-Max, CMOS, PDSO6, 1.20 X
RP504K121A2-E2 RICOH

获取价格

Switching Controller
RP504K121A5-E2 RICOH

获取价格

Switching Controller
RP504K121AD-TR RICOH

获取价格

DC-DC Regulated Power Supply Module, 1 Output, Hybrid, HALOGEN FREE AND ROHS COMPLIANT, DF
RP504K121A-E2 RICOH

获取价格

Switching Controller, Voltage-mode, 0.9A, 2550kHz Switching Freq-Max, CMOS, PDSO6, 1.20 X
RP504K121D2-E2 RICOH

获取价格

Switching Controller