MODEL: R7I4DECT-1-DAC32C
Remote I/O R7I4D Series
[1] OPTIONS (multiple selections)
Wire Breakdown Detection
Blank: With
EtherCAT I/O MODULE
(NPN discrete input & NPN transistor output, 16 points each,
/D1: Without
Other Options
e-CON connector)
blank: none
Functions & Features
/Q: With options (specify the specification)
• 16 points NPN discrete input and 16 points NPN transistor
output module for EtherCAT
SPECIFICATIONS OF OPTION: Q (multiple selections)
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
EtherCAT® is a registered trademark and patented
technology, licensed by Beckhoff Automation GmbH,
Germany.
/C02: Polyurethane coating
/C03: Rubber coating
EX-FACTORY SETTING
/SET: Preset according to the Ordering Information Sheet
(No. ESU-7779-DAC32)
165 (6.50)
RELATED PRODUCTS
• PC configurator software (model: R7CFG)
53.5 (2.11)
• ESI file
41 (1.61)
The configurator software and ESI files are downloadable at
M-System’s web site.
mm (inch)
Use a commercially available Mini-B USB cable to connect
the unit to a PC.
MODEL: R7I4DECT-1-DAC32C-R[1]
GENERAL SPECIFICATIONS
Connection
ORDERING INFORMATION
• Code number: R7I4DECT-1-DAC32C-R[1]
Specify a code from below for [1].
(e.g. R7I4DECT-1-DAC32C-R/D1/Q)
• Specify the specification for option code /Q
(e.g. /C01/SET)
EtherCAT: RJ-45 Modular Jack
Power & Sensor excitation: Separable screwless spring
terminal
I/O: e-CON connector
Housing material: Flame-resistant resin (gray)
Isolation: Input or output or sensor excitation to EtherCAT or
FE to power
TERMINAL BLOCK
1: Tension clamp terminal block for power supply
RJ-45 Modular jack for communication
e-CON connector for I/O
Output at the loss of communication: Configurable via
R7CFG
Status indicator LED: PWR, RUN, ERR, L/A IN, L/A OUT
(Refer to the instruction manual.)
Discrete I/O status indicator LED: Green LED turns on with
I/O ON
I/O TYPE
DAC32C: NPN discrete input &
Read rate: Selectable with R7CFG
NPN transistor output, 16 points each
EtherCAT COMMUNICATION
Standard: IEEE 802.3u
POWER INPUT
DC Power
Transmission type: 100BASE-TX
R: 24 V DC
Transmission speed: Full-duplex 100 Mbps
Transmission media: 100BASE-TX (STP cable; Category 5e)
Maximum internode length: 100 meters
Fixed address: Set with rotary switches
(The master must support MDP.)
(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)
R7I4DECT-1-DAC32C SPECIFICATIONS
ES-7779-C Rev.0 Page 1/9
http://www.m-system.co.jp/