MODEL: R7I4DECT-1-DC32A
blank: none
Remote I/O R7I4D Series
/Q: With options (specify the specification)
EtherCAT I/O MODULE
(NPN transistor output, 32 points each, e-CON connector)
SPECIFICATIONS OF OPTION: Q (multiple selections)
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
Functions & Features
• 32 points NPN transistor output module for EtherCAT
/C02: Polyurethane coating
/C03: Rubber coating
EtherCAT® is a registered trademark and patented
technology, licensed by Beckhoff Automation GmbH,
Germany.
EX-FACTORY SETTING
/SET: Preset according to the Ordering Information Sheet
(No. ESU-7779-DC32)
RELATED PRODUCTS
165 (6.50)
• PC configurator software (model: R7CFG)
• ESI file
The configurator software and ESI files are downloadable at
M-System’s web site.
53.5 (2.11)
Use a commercially available Mini-B USB cable to connect
the unit to a PC.
41 (1.61)
mm (inch)
GENERAL SPECIFICATIONS
Connection
MODEL: R7I4DECT-1-DC32A-R[1]
EtherCAT: RJ-45 Modular Jack
Power & Sensor excitation: Separable screwless spring
terminal
ORDERING INFORMATION
• Code number: R7I4DECT-1-DC32A-R[1]
Specify a code from below for [1].
(e.g. R7I4DECT-1-DC32A-R/D1/Q)
• Specify the specification for option code /Q
(e.g. /C01/SET)
Output: e-CON connector
Housing material: Flame-resistant resin (gray)
Isolation: Output or sensor excitation to EtherCAT or FE to
power
Output at the loss of communication: Configurable via
R7CFG
Status indicator LED: PWR, RUN, ERR, L/A IN, L/A OUT
(Refer to the instruction manual.)
Discrete Output status indicator LED: Green LED turns on
with Output ON
TERMINAL BLOCK
1: Tension clamp terminal block for power supply
RJ-45 Modular jack for communication
e-CON connector for I/O
EtherCAT COMMUNICATION
Standard: IEEE 802.3u
I/O TYPE
DC32A: NPN transistor output, 32 points
Transmission type: 100BASE-TX
Transmission speed: Full-duplex 100 Mbps
Transmission media: 100BASE-TX (STP cable; Category 5e)
Maximum internode length: 100 meters
Fixed address: Set with rotary switches
(The master must support MDP.)
POWER INPUT
DC Power
R: 24 V DC
(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)
[1] OPTIONS (multiple selections)
Wire Breakdown Detection
Blank: With
OUTPUT SPECIFICATIONS
Common: Negative common (NPN) per 32 points
Maximum outputs applicable at once: No limit (at 24 V DC)
Sensor Excitation: 24 V DC ±10 %, ripple 5 %p-p max.,
≤ 5 A (including discrete output load charge); rated current
/D1: Without
Other Options
R7I4DECT-1-DC32A SPECIFICATIONS
ES-7779-J Rev.1 Page 1/7
http://www.m-system.co.jp/