P
ualtek
Q
P
C
35Watts Single Output
QPS-35 Series
Electronics Corporation
Features:
Universal AC input/ Full range
High Efficiency, Low Power Consumption
Output Protections: OLP/OVP/SCP
Wide operating ambient temperature (-20°C~65°C)
No fan required, suitable for quiet environments
All using 105°C long life electrolytic capacitors.
100% full load burn-in test
CB
QPS-35-5 QPS-35-12 QPS-35-13.5 QPS-35-15 QPS-35-24 QPS-35-36
QPS-35-48
Model
Output Characteristics
5V
12V
13.5V
15V
24V
36V
48V
DC Output
6.0A
3.0A
2.6A
2.4A
1.5A
1.0A
0.75A
Rated Current
Current Range (Note 1)
0~6.0A
≤80mV
≤150mV
0~3.0A
≤120mV
≤200mV
0~2.6A
≤120mV
≤200mV
0~2.4A
≤120mV
≤200mV
0~1.5A
≤120mV
≤200mV
0~1.0A
≤120mV
≤200mV
0~0.75A
≤120mV
≤200mV
Ripple and
Noise (Note 2)
0~65°C
-20~0°C
-5% ~ +10% of rated output voltage
Voltage ADJ. Range
Voltage Accuracy
Line Regulation
Load Regulation
Set-up Time
1.0%
0.5%
1.0%
≤2.0s (115VAC input, full load) ≤1.0s (230VAC input, full load)
≥10ms (115VAC input, full load) ≥20ms (230VAC input, full load)
Hold-up Time
0.03%/°C
<5.0%
Temperature Coefficient
Overshoot and Undershoot
Input Characteristics
Voltage Range
Frequency Range
90VAC~264VAC
47Hz-63Hz
Efficiency (Typical) 220VAC Input 78%
81%
82%
83%
83%
84%
86%
AC Current (max)
Inrush Current (Typical)
Leakage Current
<1.0A
<23A@115VAC Cold start <45A@230VAC Cold start
Input-Output: <0.25mA Input-PG: <3.5mA
Protection
Over Load (OLP)
105%~180% of rated output current, hiccup mode, auto recovery
13.8V~16.2V 15.5V~18.2V 17.25V~20.25V 27.6V~32.4V 41.4V~48.6V 55.2V~64.8V
Over Voltage (OVP)
5.75V~7.5V
Protection Type: Constant Voltage, auto recovery
Long-term mode, auto recovery
Short Circuit (SCP)
Environmental Characteristics
Operating Amb. Temp. & Hum -20°C~65°C; 20%~90% RH Non-Condensing
Storage Temp. & Hum
Safety Standards
-30°C~85°C: 10%-95% RH Non-Condensing
UL60950-1; IEC60950; EN60950-1: 2006
Withstand Voltage
Primary-Secondary: 3.0KVAC;≤10mA. Primary-PG: 1.5KVAC;≤10mA. Secondary-PG: 0.5KVDC;≤10mA
≥100M ohms
Compliance to EN55022 (CISPR22)Class B
Isolation Resistance
EMI Conduction & Radiation
EMS Immunity
Compliance to EN61000-4-2, 3, 4, 5, 6, 8, 11; ENV50204, light industry level, criteria A
General Characteristics
MTBF (MIL-HDBK-217F)
Dimension (LxWxH)
Packing
More than 200,000Hrs (35°C, Full load)
101.6x50.8x24mm
60PCS/CTN. G.W: 11.0kgs
Cooling by free air convection
Cooling Method
Note
1. All parameters NOT specially mentioned are measured at rated input, rated load, and 25°C of ambient temperature
2. Measured at 20MHz of bandwith by using a 12” Twisted pair wire terminated with a 0.1uF & 47uF parallel capacitor
3. The SPS is considered a component which will be installed into final equipment. The equipment must be re-confirmed that it still meets EMC directives.
Page 1 of 2