PTH12000W/L — 12-V Input
6-A, 12-V Input Non-Isolated
Wide-Output Adjust Power Module
SLTS202E– MAY 2003 – REVISED NOVENBER 2007
Features
• Up to 6-A Output Current
• 12-V Input Voltage
• Wide-Output Voltage Adjust
(1.2 V to 5.5 V)/(0.8 V to 1.8 V)
• 230 W/in³ Power Density
• Efficiencies up to 92 %
• Pre-Bias Startup
• Under-Voltage Lockout
• Output Over-Current Protection
(Non-Latching, Auto-Reset)
• Operating Temp: –40 to +85 °C
• Surface Mount Package
• Safety Agency Approvals:
UL/cUL 60950, EN60950
VDE
NOMINAL SIZE =
0.75 in x 0.5 in
(19,05 mm x 12,7 mm)
• On/Off Inhibit
Description
Pin Configuration
put voltage is set within the adjustment
range using a single external resistor.
Operating features include an on/off
inhibit, output voltage adjust (trim), and
the ability to start up into an existing
output voltage or prebias. A non-latching
over-current trip provides protection
against load faults.
Target applications include telecom,
industrial, and general purpose circuits,
including low-power dual-voltage systems
that use a DSP, microprocessor, or ASIC.
Package options include both through-
hole and surface mount configurations.
The PTH12000 series of non-isolated
power modules are small in size and high
on performance. Using double-sided sur-
face mount construction and synchronous
rectification technology, these regulators
deliver up to 6 A of output current while
occupying a PCB area of about half the
size of a standard postage stamp. They
are an ideal choice for applications where
space, performance and cost are impor-
tant design constraints.
Pin Function
1
2
3
4
5
GND
Vin
Inhibit *
Vo Adjust
Vout
*
Denotes negative logic:
Open = Output On
Ground = Output Off
The series operates from an input volt-
age of 12 V to provide step-down power
conversion to a wide range of output volt-
ages. W-suffix devices are adjustable from
1.2 V to 5.5 V, and L-suffix devices are
adjustable from 0.8 V to 1.8 V. The out-
Standard Application
R
= Required to set the output voltage higher than
the lowest value (see spec. table for values).
= Required 100 μF capacitor
= Optional 100 μF capacitor
= Optional 10 μF ceramic capacitor
set
C
C
C
1
2
3
VOUT
1
5
VIN
PTH12000x
(Top View)
2
3
Inhibit
4
+
COUT
100 µF
+
(Optional)
CIN
100 µF
(Required)
RSET, 1%
(Required)
GND
GND
For technical support and further information visit http://power.ti.com