PTH05050W —5-V Input
6-A, 5-V Input Non-Isolated
Wide-Output Adjust Power Module
SLTS213C – MAY 2003 – REVISED MAY 2004
Features
• Up to 6-A Output Current
• 5-V Input Voltage
• Wide-Output Voltage Adjust
(0.8 V to 3.6 V)
• Auto-Track™ Sequencing
• Output Over-Current Protection
(Non-Latching, Auto-Reset)
• IPC Lead Free 2
• Efficiencies up to 95 %
• 135 W/in³ Power Density
• On/Off Inhibit
• Safety Agency Approvals:
UL 1950, CSA 22.2 950, EN60950
VDE (Pending)
• Point-of-Load Alliance (POLA)
Compatible
• Pre-Bias Startup
• Under-Voltage Lockout
NOMINAL
SIZE
=0.87
in
x
0.5
in
• Operating Temp: –40 to +85 °C
(22,1 mm x 12,57 mm)
Description
Pin Configuration
over the range, 0.8 V to 3.6 V, using a
single resistor.
Pin Function
The PTH05050 is one of the smallest
non-isolated power modules from Texas
Instruments that features Auto-Track™.
Auto-Track simplifies supply voltage
sequencing in power systems by enabling
modules to track each other, or any other
external voltage, during power up and
power down.
Although small in size (0.87 in × 0.5 in),
these modules are rated for up to 6 A of
output current, and are an ideal choice in
applications where space, performance,
and a power-up sequencing capability are
important attributes.
1
2
3
4
5
6
GND
Track
Vin
Inhibit *
Vo Adjust
Vout
Other operating features include an
on/off inhibit, output voltage adjust (trim),
and output over-current protection. For
high efficiency these parts employ a
synchronous rectifier output stage, but a
pre-bias hold-off capability ensures that
the output will not sink current during
startup.
Target applications include telecom,
industrial, and general purpose circuits,
including low-power dual-voltage systems
that use a DSP, microprocessor, ASIC, or
FPGA.
*
Denotes negative logic:
Open
= Normal operation
Ground = Function active
The product provides high-performance
step-down conversion from a 5-V input
bus voltage. The output voltage of the
PTH05050W can be set to any voltage
Package options include both through-
hole and surface mount configurations.
Standard Application
R
= Required to set the output voltage to a value
higher than 0.8 V. (See spec. table for values)
set
C
= Required 100 µF
in
Co = Optional 100 µF capacitor
1
Co2 = Optional 10 µF ceramic capacitor for reduced
output ripple.
Track
VIN
VOUT
1
2
3
4
6
5
PTH05050W
(Top View)
Co1
100 µF
Electrolytic
(Optional)
Co2
10 µF
Ceramic
(Optional)
CIN
100 µF
(Required)
RSET
1 %, 0.1 W
(Required)
Inhibit
GND
GND
For technical support and further information, visit http://power.ti.com