Part Number 440EP
Revision 1.26 – April 25, 2007
Data Sheet
440EP
Power PC 440EP Embedded Processor
Features
®
• Two Ethernet 10/100Mbps half- or full-duplex
interfaces. Operational modes supported are MII,
RMII, and SMII with packet reject.
• PowerPC 440 processor core operating up to
667MHz with 32KB I-cache and D-cache with
parity checking.
• Up to four serial ports (16750 compatible UART).
• Selectable processor:bus clock ratios of N:1, N:2.
• Two USB ports. One USB 1.1 Host interface with
on-chip PHY. One USB 2.0 Device interface, with
dedicated DMA, configured as a 1.1 on-chip PHY
or a 2.0 UTMI.
• Floating Point Unit with single- and double-
precision and single-cycle throughput.
• Dual bridged Processor Local Buses (PLBs) with
64- and 128-bit widths.
• External peripheral bus (16-bit data) for up to six
devices with external mastering.
• Double Data Rate (DDR) Synchronous DRAM
(SDRAM) interface operating up to 133MHz with
ECC.
• Two IIC interfaces (one with boot parameter read
capability).
• DMA support for external peripherals, internal
UART and memory.
• NAND Flash interface.
• SPI interface.
• PCI V2.2 interface (3.3V only). Thirty-two bits at
up to 66MHz.
• General Purpose I/O (GPIO) interface.
• JTAG interface for board level testing.
• Programmable interrupt controller supports
interrupts from a variety of sources.
• Boot from PCI memory, NOR Flash on the
external peripheral bus, or NAND Flash on the
NAND Flash interface.
• Programmable General Purpose Timers (GPT).
• Available in RoHS compliant lead-free package.
Description
Designed specifically to address high-end embedded
applications, the PowerPC 440EP (PPC440EP)
provides a high-performance, low- power solution that
interfaces to a wide range of peripherals and
Technology: CMOS Cu-11, 0.13μm.
Package: 35mm, 456-ball standard plastic ball grid
array (E-PBGA), with and without lead (RoHS
compliant).
incorporates on-chip power management features.
Typical power (measured): Less than 3W at 533MHz,
2.5W at 400MHz.
This chip contains a high-performance RISC
processor, a floating point unit, DDR SDRAM
controller, PCI bus interface, control for external ROM
and peripherals, DMA with scatter-gather support,
Ethernet ports, serial ports, IIC interfaces, SPI
interface, USB ports, NAND Flash interface, and
general purpose I/O.
Supply voltages required: 3.3V, 2.5V, 1.5V.
AMCC Proprietary
1