Short-Form Datasheet
P8910
PMIC with Step-Down Switching and LDO Regulators
The P8910 is a highly integrated, highly efficient
PMIC with programmable precise output voltage
power solution for all DDR5 Server DIMM modules,
with four step-down switching output regulators and
three LDO output regulators. The PMIC is fully
compliant to the JEDEC DDR5 PMIC (PMIC5010;
Low Current PMIC) specification. The PMIC is
powered from two input power supplies (VIN_Mgmt
and VIN_Bulk) from the system board to power its
switching and LDO output regulators.
Features
• VIN_Bulk input supply range: 4.25V to 15.0V
• VIN_Mgmt input supply range: 3.0V to 3.6V
• Four step-down switching regulators: SWA, SWB,
SWC, and SWD
• Programmable dual-phase and single-phase
regulator for SWA and SWB
• Three LDO regulators: VBias, VOUT_1.8V,
VOUT_1.0V
The P8910 has numerous advanced protection
schemes to protect itself as well to protect entire BOM
contents of DDR5 server DIMM modules. The PMIC
offers write protect operation to defend against
malicious attacks, and has an advanced I3C bus that
can operate at maximum speed of 12.5MHz with low
voltage I/O operation.
• Automatic switchover from VIN_Mgmt input supply
to VIN_Bulk input supply
• Error injection capability
• Error log registers
• Write protect mode of operation
The PMIC is available in small 5 × 5 mm form factor in
VFQFPN package with enhanced solder joint
reliability and thermal dissipation.
• Independently programmable output voltages,
power up and power down sequence for switch
regulators
• Input and output power-good status reporting
mechanism
Block Diagram
• VIN_Bulk input supply protection feature: Input
overvoltage and input undervoltage
LDO
LDO
1.8V
1.0V
5.0V
Supply Interface
LDO (VBIAS)
• Output switch regulators protection feature: Output
overvoltage, output undervoltage, output current
limiter
VIN_Bulk (12V)
I2C & I3C, 2nd
I2C Interface
SWA
SWB
VDD (1.1V)
• Output current measurement, output current
threshold mechanism
VIN_Mgmt (3.3V)
ADC, OSC, Logic
• Temperature measurement, temperature warning
threshold, critical temperature shutdown
VDDQ (1.1V)
VPP (1.8V)
SWC
SWD
MTP
• Multi Time Programmable Non-Volatile Memory
• Programmable and DIMM specific registers for
customization
• General Status Interrupt Function
Typical Applications
• Flexible Open-Drain IO (3.3V, 2.5V, 1.8V, or 1.2V or
1.1V or 1.0V) or Push-Pull IO (1.2V or 1.1V or 1.0V)
Support
• DDR5 RDIMM for Server/Workstations
• DDR5 LRDIMM for Server/Workstations
• DDR5 NVDIMM for Server/Workstations
Ordering Information
Part Number
Package Description
36-VFQFPN, 5 × 5 mm
36-VFQFPN, 5 × 5 mm
Carrier Type
Temperature Range
-10 to 125°C
Device Revision
P8910-X0Z001FNG
P8910-X0Z001FNG8
Tray
Revision B0
Tape and Reel
-10 to 125°C
R10DO0003EU0100 Rev.1.00
Mar 15, 2022
Page 1
© 2022 Reneas Electronics