P6SMB Series
Surface-mount Transient Voltage Suppressor
PRODUCT SUMMARY
Voltage range 6.8 to 200 Volts
600 Watts Peak Power
3.0 Watts Steady state
SMB/DO-214AA
FEATURES
For surface-mount applications in order to optimize board space.
Low profile package.
.082(2.08)
.076(1.93)
Built-in strain relief.
Glass-passivated junction.
.147(3.73)
.137(3.48)
Excellent clamping capability.
Fast response time: typically less than 1.0ps from 0 volt to BV min.
Typical IR less than 1μA above 10V
.187(4.75)
.167(4.25)
High temperature soldering guaranteed
260°C / 10 seconds at terminals
.012(.31)
.006(.15)
Plastic material used carries Underwriters Laboratory
Flammability Classification 94V-0
Peak pulse power capability of 600W with a 10 x 1000 us
waveform with 0.01% duty cycle
.103(2.61)
.078(1.99)
.012(.31)
.006(.15)
.056(1.41)
.035(0.90)
MECHANICAL DATA
.008(.20)
.004(.10)
Case: Molded plastic
.208(5.28)
.200(5.08)
Terminals: Matte-Sn plated
Polarity: Indicated by cathode band
Standard packaging: 12mm tape (EIA STD RS-481)
Weight: 0.093 gram
Dimensions in inches and (millimeters)
Pb-free, RoHS compliant.
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating at 25°C ambient temperature unless otherwise specified.
Parameter
Symbol
Value
Units
Peak power dissipation at TA=25°C, Tp=1ms
(Note 1)
PPK
Minimum 600
Watts
Steady state power dissipation
Pd
3
Watts
Amps
Peak forward surge current, 8.3 ms single half
sine-wave superimposed on rated load
(JEDEC method) (Note 2, 3) - Unidirectional Only
IFSM
100
Maximum instantaneous forward voltage at
50.0A for unidirectional only (Note 4)
Typical thermal resistance (Note 5)
VF
3.5/5.0
Volts
RθJC
RθJA
TJ, TSTG
10
55
°C/W
°C
Operating and storage temperature range
-65 to + 150
Notes: 1. Non-repetitive current pulse per Fig. 3 and derated above TA=25°C per Fig. 2.
2. Mounted on 5.0mm2 (.013 mm thick) copper pads to each terminal.
3. 8.3ms single half sine-wave or equivalent square wave, duty cycle=4 pulses per minute
maximum.
4. VF=3.5V on P6SMB6.8 thru P6SMB91 devices and VF=5.0V on SMBJ100 thru SMBJ200
devices.
5. Measured on P.C.B. with 0.27" x 0.27”(7.0mm x 7.0mm) copper pad areas.
For bi-directional applications:
1. Change to C or CA suffix for types P6SMB6.8 through types P6SMB200A.
2. Electrical characteristics apply in both directions.
11/26/2005 Rev.3.01
www.SiliconStandard.com
1 of 5