Data Sheet
6.8V to 200V GPP TRANSIENT
VOLTAGE SUPPRESSORS
TVS
Device
Mechanical Dimensions
Description
Load
.230
.300
1.00 Min.
JEDEC
D0-15
Uni-Polar
TVS
Device
.104
.140
Load
.031 typ.
Bi-Polar
Features
n 600 WATT PEAK POWER PROTECTION
n EXCELLENT CLAMPING CAPABILITY
n FAST RESPONSE TIME
n TYPICAL IR < 1µA ABOVE 10V
GLASSPASSIVATEDCHIPCONSTRUCTION
n MEETS UL SPECIFICATION 94V-0
n
P6KE Series
(For Bi-Polar Applications, See Note 1)
Units
Maximum Ratings
Watts
......................................... 600 Min. ..........................................
Peak Power Dissipation...PPK
TP = 1ms (Note 5)
Watts
Amps
.............................................
5
...............................................
Steady State Power Dissipation...PD
@ TL= 75°C
............................................. 100 ...............................................
Non-Repetitive Peak Forward Surge Current...IFSM
@ Rated Load Conditions, 8.3 ms, ½ Sine Wave, Single Phase
(Note 3)
Grams
............................................. 0.34 ...............................................
............................................. 10 Sec. ...........................................
Weight...GRM
Soldering Requirements (Time & Temp)...ST
Min. to
Solder
@ 250°C
°C
......................................... -65 to 175 ..........................................
Operating & Storage Temperature Range...TJ, TSTRG
NOTES: 1. For Bi-Directional Applications, Use C or CA. Electrical Characteristics Apply in Both Directions.
2. Mounted on 40mm2 Copper Pads.
3. 8.3 ms, ½ Sine Wave, Single Phase Duty Cycle, @ 4 Pulses Per Minute Maximum.
4. V Measured After IT Applies for 300 µs. IT = Square Wave Pulse or Equivalent.
5. NBoRn-Repetitive Current Pulse. Per Fig. 3 and Derated Above TA = 25°C Per Fig. 2.
Page 11-10