Data Sheet
May, 2006
®
ORCA Series 4 FPGAs
■ Traditional I/O selections:
— LVTTL (3.3V) and LVCMOS (2.5 V and 1.8 V)
I/Os.
Introduction
Built on the Series 4 reconfigurable embedded sys-
tem-on-a-chip (SoC) architecture, Lattice introduces
its new family of generic Field-Programmable Gate
Arrays (FPGAs). The high-performance and highly
versatile architecture brings a new dimension to
bringing network system designs to market in less
time than ever before. This new device family offers
many new features and architectural enhancements
not available in any earlier FPGA generations. Bring-
ing together highly flexible SRAM-based programma-
ble logic, powerful system features, a rich hierarchy
of routing and interconnect resources, and meeting
multiple interface standards, the Series 4 FPGA
accommodates the most complex and high-perfor-
mance intellectual property (IP) network designs.
— Per pin-selectable I/O clamping diodes provide
3.3 V PCI compliance.
— Individually programmable drive capability:
24 mA sink/12 mA source, 12 mA sink/6 mA
source, or 6 mA sink/3 mA source.
— Two slew rates supported (fast and slew-lim-
ited).
— Fast-capture input latch and input flip-flop
(FF)/latch for reduced input setup time and zero
hold time.
— Fast open-drain drive capability.
— Capability to register 3-state enable signal.
— Off-chip clock drive capability.
— Two-input function generator in output path.
■ New programmable high-speed I/O:
— Single-ended: GTL, GTL+, PECL, SSTL3/2
(class I and II), HSTL (Class I, III, and IV), ZBT,
and DDR.
— Double-ended: LDVS, bused-LVDS, and
LVPECL. Programmable (on/off) internal parallel
termination (100 Ω) also supported for these
I/Os.
Programmable Features
■ High-performance platform design:
— 0.16 μm 7-level metal technology.
— Internal performance of >250 MHz.
— I/O performance of >420 MHz.
— Meets multiple I/O interface standards.
— 1.5 V operation (30% less power than 1.8 V
operation) translates to greater performance.
Table 1. ORCA Series 4—Available FPGA Logic
EBR
Blocks
EBR Bits
(K)
Usable*
Gates (K)
Device
Rows
Columns
PFUs
User I/O
LUTs
OR4E02
OR4E04
OR4E06
26
36
46
24
36
44
624
405
466
466
4,992
10,368
16,192
8
74
201—397
333—643
471—899
1,296
2,024
12
16
111
148
* The embedded system bus and MPI are not included in the above gate counts. The System Gate ranges are derived from the following:
minimum system gates assumes 100% of the PFUs are used for logic only (no PFU RAM) with 40% EBR usage and 2 PLLs. Maximum
system gates assumes 80% of the PFUs are for logic, 20% are used for PFU RAM, with 80% EBR usage and 6 PLLs.
Note: Devices are not pinout compatible with ORCA Series 2/3.
© 2005 Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at www.latticesemi.com/legal. All
other brand or product names are trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to
change without notice.
www.latticesemi.com
1
or4e_05