12-Channel, 300 V CAT II, 600 V CAT I Multiplexer
NI PXI-2584 NEW!
• Dual 6x1 1-wire, 12x1 1-wire,
6x1 2-wire, interleaved 11x1 2-wire
multiplexer configuration
Operating Systems
• Windows 2000/XP
• Linux®
• Switching capacity
Recommended Software
• NI Switch Executive
• LabVIEW
• LabWindows/CVI
• Measurement Studio
• Up to 300 V CAT II, 600 V CAT I
• Up to 0.5 A switching/0.5 A carry
• Up to 10 W
• 600 channels/s
• Onboard relay counting
• Fully software programmable
Other Compatible Software
• Visual Basic
• C/C++
• 32,000-step scanlist for
deterministic scanning
• Tight synchronization with instruments
through hardware triggers
Driver Software (included)
• NI-SWITCH
• NI-DAQmx
Overview
The National Instruments PXI-2584 is a high-voltage multiplexer
switch in a single-slot, 3U PXI module. With a CAT II certification at
300 V, it is capable of routing general-purpose ATE loads or high-voltage,
low-current signals. The 600 V CAT I channel-to-ground isolation on the
NI PXI-2584 makes it ideal for fuel cell and battery stack applications.
You also can use the module in multimodule configurations for taking
measurements on hundreds of channels. The CAT I and CAT II safety
ratings combined with UL safety certification make it ideally suited for
high-voltage ATE systems that include the NI PXI-4071 1000 V digital
multimeter. The reed relays in the PXI-2584 also ensure longer
lifetimes and faster actuation times for test equipment.
Interleaved Topology for
Maximum Channel Count
Interleaved topology is a method to increase channel count when
measuring potentials that are on a stack such as battery stacks and fuel
cell stacks. In traditional 2-wire topologies, each channel would put two
wires across each component under test, which would limit the PXI-2584
to six differential channels. By putting each single input pin on the front
connector at points in between potentials on a stack, the channel count
is extended from six to 11 2-wire channels. In addition to maximizing
channel count on a module, the topology offers a free “straddle”
channel when testing battery stacks over multiple modules.
The PXI-2584 Interleaved Topology Maximizes Channel Count