MX25L6405
Macronix NBitTM Memory Family
64M-BIT [x 1] CMOS SERIAL eLiteFlashTM MEMORY
FEATURES
GENERAL
• Auto Erase and Auto Program Algorithm
• Serial Peripheral Interface (SPI) compatible -- Mode 0
and Mode 3
- Automatically erases and verifies data at selected
sector
• 67,108,864 x 1 bit structure
- Automatically programs and verifies data at selected
page by an internal algorithm that automatically times
the program pulse widths (Any page to be programed
should have page in the erased state first)
• Status Register Feature
• 128 Equal Sectors with 64K byte each
- Any sector can be erased
• Single Power Supply Operation
- 2.7 to 3.6 volt for read, erase, and program operations
• Latch-up protected to 100mA from -1V to Vcc +1V
• Low Vcc write inhibit is from 1.5V to 2.5V
• Electronic Identification
- JEDEC 2-byte Device ID
- RES command, 1-byte Device ID
PERFORMANCE
- REMS command, ADD=00H will output the
manufacturer's ID first and ADD=01H will output device
ID first
• High Performance
- Fast access time: 50MHz serial clock (30pF + 1TTL
Load)
• Additional 4Kb sector independent from main memory
for parameter storage to eliminate EEPROM from
system
- Fast program time: 3ms/page (typical, 256-byte per
page)
- Fast erase time: 1s/sector (typical, 64K-byte per
sector) and 128s/chip (typical)
- Acceleration mode:
HARDWAREFEATURES
• SCLK Input
- Program time: 2.4ms/page (typical)
- Erase time: 0.8s/sector (typical) and 102s/chip
(typical)
- Serial clock input
• SI Input
- Serial Data Input
• Low Power Consumption
• SO/PO7
- Serial Data Output or Parallel mode Data output/input
• WP#/ACC Pin
- Low active read current: 30mA (max.) at 50MHz
- Low active programming current: 30mA (max.)
- Low active erase current: 38mA (max.)
- Low standby current: 50uA (max.)
-Deeppower-downmode1uA(typical)
- Hardware write protection and Program/erase accel-
eration
• HOLD# pin
- pause the chip without diselecting the chip (not for
paralled mode, please connect HOLD# pin toVCC dur-
ing parallel mode)
• Minimum 10K erase/program cycle for array
• Minimum 100K erase/program cycle for additional 4Kb
SOFTWAREFEATURES
• Input Data Format
• PO0~PO6
- for parallel mode data output/input
• PACKAGE
- 1-byte Command code
- 16-pin SOP (300mil)
- All Pb-free devices are RoHS Compliant
P/N:PM1107
REV. 1.3, NOV. 06, 2006
1