MX25L12873G
3V 128M-BIT [x 1/x 2/x 4] CMOS MXSMIO® (SERIAL MULTI I/O)
FLASH MEMORY
1. FEATURES
GENERAL
•
•
•
Command Reset
•
Supports Serial Peripheral Interface -- Mode 0 and
Mode 3
Program/Erase Suspend and Resume operation
Electronic Identification
•
Single Power Supply Operation
- 2.7 to 3.6 volt for read, erase, and program
operations
JEDEC 1-byte manufacturer ID and 2-byte device
ID
-
- RES command for 1-byte Device ID
- REMS command for 1-byte manufacturer ID and
1-byte device ID
Support Serial Flash Discoverable Parameters
(SFDP) mode
•
128Mb: 134,217,728 x 1 bit structure or 67,108,864
x 2 bits (two I/O mode) structure or 33,554,432 x 4
bits (four I/O mode) structure
•
•
Protocol Support
- Single I/O, Dual I/O and Quad I/O
Latch-up protected to 100mA from -1V to Vcc +1V
Fast read for SPI mode
HARDWARE FEATURES
•
•
•
SCLK Input
- Serial clock input
SI/SIO0
- Support clock frequency up to 133MHz for all
protocols
•
- Serial Data Input or Serial Data Input/Output for 2
x I/O read mode and 4 x I/O read mode
SO/SIO1
- Serial Data Output or Serial Data Input/Output for
2 x I/O read mode and 4 x I/O read mode
SIO2
- Serial data Input & Output for 4 x I/O read mode
SIO3
- Serial data Input & Output for 4 x I/O read mode
PACKAGE
- Support Fast Read, 2READ, DREAD, 4READ,
QREAD instructions
- Support DTR (Double Transfer Rate) Mode
- Configurable dummy cycle number for fast read
operation
Default Quad I/O enable (QE bit=1), and can not be
change
Quad Peripheral Interface (QPI) available
Equal Sectors with 4K byte each, or Equal Blocks
with 32K byte each or Equal Blocks with 64K byte
each
•
•
•
•
•
•
•
- 16-pin SOP (300mil)
- 8-pins SOP (200mil)
- 8-land WSON (6x5mm)
- Any Block can be erased individually
Programming:
•
- All devices are RoHS Compliant and Halogen-
free
- 256byte page buffer
- Quad Input/Output page program(4PP) to enhance
program performance
•
•
Typical 100,000 erase/program cycles
20 years data retention
SOFTWARE FEATURES
•
Input Data Format
- 1-byte Command code
•
Advanced Security Features
- Block lock protection
The BP0-BP3 and T/B status bits define the size of
the area to be protected against program and erase
instructions
- Individual sector protection function (Solid Protect)
Additional 4K bit security OTP
•
Features unique identifier
Factory locked identifiable, and customer lockable
-
-
P/N: PM2419
Rev. 1.1, October 05, 2017
4