MN101C73 Series
Type
MN101C73A
MN101CF73A
Internal ROM type
ROM (byte)
Mask ROM
FLASH
32K
RAM (byte)
1.5K
2K
Package (Lead-free)
LQFP064-P-1414, TQFP064-P-1010C
0.1 µs (at 3.0 V to 3.6 V, 10 MHz)
0.235 µs (at 1.8 V to 3.6 V, 4.25 MHz)*
62.5 µs (at 1.8 V to 3.6 V, 32 kHz)*
Minimum Instruction
Execution Time
*: The lower limit for operation guarantee for flash memory built-in type is 2.2 V.
Interrupts
RESET. Watchdog. External 0 to 5. External 6 (key interrupt dedicated). Timer 0 to 3. Timer 6. Timer 7 (2 systems). Timer 8 (2 systems).
Time base. Serial 0 (2 systems). Serial 1 (2 systems). Serial 3. A/D conversion finish
Timer Counter
8-bit timer × 5
Timer 0 ..................Square-wave/8-bit PWM output. Event count. Remote control carrier output. Simple pulse width measurement.
Added pulse (2-bit) type PWM output. Square-wave/PWM output to large current terminal P50 possible
Timer 1 ..................Square-wave output. Event count. Synchronous output event
Timer 2 ..................Square-wave output. Added pulse (2-bit) type PWM output. PWM output. Serial transfer clock output. Event
count. Synchronous output event. Simple pulse width measurement. Square-wave/PWM output to large current
terminal P51 possible
Timer 3 ..................Square-wave output. Event count. Serial transfer clock output
Timer 6 ..................8-bit freerun timer
Timer 0, 1 can be cascade-connected
Timer 2, 3 can be cascade-connected
16-bit timer × 2
Timer 7 ..................Square-wave output. 16-bit PWM output (cycle/duty continuous variable). Event count. Synchronous output
event. Pulse width measurement. Input capture. Real time output control. High performance IGBT output. Square-
wave/PWM output to large current terminal P52 possible
Timer 8 ..................Square-wave/16-bit PWM output (duty continuous variable). Event count. Pulse width measurement. Input
capture. Square-wave/PWM output to large current terminal P53 possible
Timer 7, 8 can be cascade-connected: Square-wave output, PWM is possible as a 32-bit timer
Time base timer: One-minute count setting
Watchdog timer × 1
Serial interface
Synchronous type/UART (full-duplex) × 2: Serial 0, 1
Synchronous type/Single-master I2C × 1: Serial 3
I/O Pins
I/O
55 : Common use. Specified pull-up resistor available. Input/output selectable (bit unit)
A/D converter
10-bit × 12 channels (with S/H)
Display control function
LCD: 32 segments × 4 commons (Static, 1/2, 1/3, or 1/4 duty)
Usable if VLCD ≤ VDD
LCD power shunt resistance contained
Special Ports
Buzzer output. Inverted buzzer output. Remote control carrier output. High-current drive port
ROM Correction
Correcting address designation: Up to 3 addresses possible
MAD00047GEM