NXP Semiconductors
Data Sheet: Technical Data
K28P210M150SF5
Rev. 4, 03/2017
Kinetis K28F MCU Sub-Family
MK28FN2M0CAU15R
MK28FN2M0VMI15
High performance ARM® Cortex®-M4 MCU with 2 MB Flash,
1 MB SRAM, 2 USB Controllers (High-Speed and Full-
Speed), SDRAM controller, QuadSPI interface and Power
Management Controller with Core Voltage Bypass.
K28F extends the Kinetis Micontroller portfolio with large
embedded memory, advanced external memory interfaces,
performance, and peripheral integration while maintaining a high
level of software compatibility with previous Kinetis devices:
• The extended memory resources include a total of 2 MB of
programmable flash and 1 MB of embedded SRAM which
can be used to support application needs for data logging
and rich human to machine interfaces with displays
• The Power Management Controller with Core Voltage
Bypass enables the use of an external PMIC to maximize
the power efficiency of the system
169 MAPBGA (MI)
9 x 9 x 1.28 mm Pitch 6.9 mm x 6.9 x 0.6 mm
0.65 mm Pitch 0.4 mm
210 WLCSP (AU)
• K28F enables memory expansion leveraging the SDRAM
controller and QuadSPI interface for eXecution-In-Place (XIP) from an external Serial NOR flash
• Both the USB High-Speed and Crystal-less Full-Speed Controllers integrate a PHY to reduce BOM cost
• The integrated smart peripherals such as Low-power UARTs and Timers operate in very low-power
modes to optimize battery life of the system
Performance
• Up to 150 MHz ARM Cortex-M4 based core with DSP
Human-machine interface
• Up to 120 General-purpose input/output (GPIOs)
instructions and Single Precision Floating Point unit
(FPU)
Analog modules
• Power Management Control (PMC) with Core Voltage
Bypass
• One 16-bit SAR ADCs, two 6-bit DAC and one 12-bit
DAC
Memories and memory expansion
• 2 MB dual bank program flash and 1 MB SRAM
• 8 KB I/D + 8 KB System cache
• 32-bit external bus interface (FlexBus)
• 32-bit SDRAM controller
• Dual QuadSPI interface with eXecution-In-Place (XIP)
• supports SDR and DDR serial flash and octal
configurations
• Two analog comparators (CMP) containing a 6-bit
DAC and programmable reference input
• 1.2 V Voltage reference
Timers
• One 4-ch 32-bit Periodic interrupt timer
• Two 16-bit low-power timer PWM modules
• Two 8-ch motor control/general purpose/PWM timers
• Two 2-ch quadrature decoder/general purpose timers
• Real-time clock with independent 3.6 V power domain
• Programmable delay block
• 32 KB Boot ROM with built-in bootloader
System and Clocks
• 32-ch Asynchronous DMA
• Multiple low-power modes
• Memory protection unit with multi-master protection
• 3 to 32 MHz main crystal oscillator
• 32 kHz low power crystal oscillator
• 48 MHz internal reference
Operating Characteristics
• Temperature range (ambient): -40 to 105°C (BGA)
Temperature range (ambient):-40 to 85°C (WLCSP)
• Hardware and Software Watchdogs
NXP reserves the right to change the production detail specifications as may be
required to permit improvements in the design of its products.