Freescale Semiconductor, Inc.
Data Sheet: Technical Data
K24P121M120SF5
Rev 2, 08/2014
Kinetis K24F Sub-Family 256 KB
MK24FN256VDC12
Flash Data Sheet
120 MHz ARM® Cortex®-M4-based Microcontroller with FPU
The K24F product family features high memory densities, low
power capabilities, and optimized integration. It shares the
comprehensive enablement and scalability of the Kinetis family.
This product offers:
• 1-1 flash to RAM ratio, with 256 KB of embedded flash and
256 KB of embedded RAM to support application with high
RAM density requirements.
• USB LS/FS OTG 2.0 with embedded 3.3 V, 120 mA LDO
voltage regulator and USB device crystal-less operation.
• Run power consumption down to 220 μA/MHz. Static
power consumption down to 3.68 μA with full state
retention and 5 μs wakeup. Lowest Static mode down to
173 nA
121 XFBGA
8 x 8 x 0.5 mm Pitch 0.65 mm
Performance
• Up to 120 MHz ARM® Cortex®-M4 core with DSP
Communication interfaces
• USB full-/low-speed On-the-Go controller
instructions and floating point unit
• USB Device Charger detect (USBDCD)
• Three SPI modules
Memories and memory interfaces
• Three I2C modules
• Up to 256 KB program flash memory and 256 KB RAM
• Serial programming interface (EzPort)
• Pre-programmed Kinetis flashloader for one-time, in-
system factory programming
• Six UART modules
• I2S module
Timers
• Two 8-channel motor control/general purpose/PWM
timers
• Two 2-channel quadrature decoder/general purpose
timers
• Periodic interrupt timers and 16-bit low power timer
• Carrier modulator transmitter
• Real-time clock
System peripherals
• Multiple low-power modes, low-leakage wakeup unit
• 16-channel DMA controller
• External watchdog monitor
• Software watchdog
Clocks
• Programmable delay block
• 3 to 32 MHz and 32 kHz crystal oscillator
• Multipurpose clock generator with FLL and PLL
• 32 kHz, and 4 MHz internal reference clock
• 48 MHz internal reference
Security and integrity modules
• Hardware CRC module
• 128-bit unique identification (ID) number per chip
Analog modules
Operating Characteristics
• Two 16-bit SAR ADCs
• 12-bit DAC
• Two analog comparators (CMP)
• Voltage reference
• Voltage range: 1.71 to 3.6 V
• Flash write voltage range: 1.71 to 3.6 V
• Temperature range (ambient): –40 to 105 °C
Freescale reserves the right to change the detail specifications as may be required to
permit improvements in the design of its products. © 2014 Freescale Semiconductor,
Inc. All rights reserved.