Document Number: MC33903_4_5
Rev. 5.0, 12/2010
Freescale Semiconductor
Advance Information
SBC Gen2 with CAN High Speed
and LIN Interface
33903/
33903/4/5
The 33903/4/5 is the second generation family of System Basis
Chips, which combines several features and enhances present module
designs. The device works as an advanced power management unit for
the MCU, additional integrated circuits such as sensors, and CAN
transceivers. It has a built-in enhanced high speed CAN interface
(ISO11898-2 and -5), with local and bus failure diagnostics, protection,
and fail safe operation mode. The SBC may include one or two LIN 2.1
interfaces with LIN output pin switches. It includes up to four wake-up
input pins than can also be configured as output drivers for flexibility.
SYSTEM BASIS CHIP
This device implements multiple Low Power modes, with very low-
current consumption. In addition, the device is part of a family concept
where pin compatibility, among the various devices with and without
LIN interfaces, add versatility to module design.
EK SUFFIX (PB-FREE)
EK SUFFIX (PB-FREE)
98ASA10556D
98ASA10506D
54-PIN SOIC
32-PIN SOIC
The 33903/4/5 also implements an innovative and advanced fail-safe
state machine and concept solution.
ORDERING INFORMATION
Features
See Device Variations on page 2
• Voltage regulator for MCU, 5.0 or 3.3 V, part number selectable, with
possibility of usage external PNP to extend current capability and
share power dissipation
• Voltage, current, and temperature protection
• Extremely low quiescent current in low power modes
• Fully-protected embedded 5.0 V regulator for the CAN driver
• Multiple under-voltage detections to address various MCU
specifications and system operation modes (i.e. cranking)
• Auxiliary 5.0 or 3.3 V SPI configurable regulator, for additional ICs,
with over-current detection and under-voltage protection
• MUX output pin for device internal analog signal monitoring and
power supply monitoring
• Advanced SPI, MCU, ECU power supply, and critical pins
diagnostics and monitoring.
• Multiple wake-up sources in low power modes: CAN or LIN bus, I/O
transition, automatic timer, SPI message, and VDD over-current
detection.
• ISO11898-5 high speed CAN interface compatibility for baud rates of
40 kb/s to 1.0 Mb/s
• Pb-free packaging designated by suffix code EK
* This document contains certain information on a new product.
Specifications and information herein are subject to change without notice.
© Freescale Semiconductor, Inc., 2010. All rights reserved.