MC78L00A Series,
NCV78L00A
100 mA Positive Voltage
Regulators
The MC78L00A Series of positive voltage regulators are
inexpensive, easy−to−use devices suitable for a multitude of
applications that require a regulated supply of up to 100 mA. Like
their higher powered MC7800 and MC78M00 Series cousins, these
regulators feature internal current limiting and thermal shutdown
making them remarkably rugged. No external components are
required with the MC78L00 devices in many applications.
These devices offer a substantial performance advantage over the
traditional zener diode−resistor combination, as output impedance
and quiescent current are substantially reduced.
http://onsemi.com
TO−92
P SUFFIX
CASE 029
1
2
3
Features
• Wide Range of Available, Fixed Output Voltages
• Low Cost
Pin: 1. Output
2. Ground
3. Input
• Internal Short Circuit Current Limiting
• Internal Thermal Overload Protection
• No External Components Required
• Complementary Negative Regulators Offered (MC79L00A Series)
• Pb−Free Packages are Available
SOIC−8*
8
D SUFFIX
CASE 751
1
• NCV Prefix for Automotive and Other Applications Requiring Site
*SOIC−8 is an internally modified SO−8 package. Pins
2, 3, 6, and 7 are electrically common to the die attach
flag. This internal lead frame modification decreases
package thermal resistance and increases power
dissipationcapability when appropriately mounted on
a printed circuit board. SOIC−8 conforms to all exter-
nal dimensions of the standard SO−8 package.
and Control Changes
Input
Q11
Q3
Q5
15k
Q12
Q1
3.8k
Q10
5.0k
3.0
Output
PIN CONNECTIONS
Q4
Q6
0−25k
1
2
3
4
8
7
6
5
V
V
IN
OUT
GND
GND
NC
GND
GND
1.9k
19k
2.2k
1.2k
420
Q9
C
NC
Q8
Q2
Z1
2.85k
(Top View)
Q7
1.0k
ORDERING INFORMATION
Ground
See detailed ordering and shipping information in the package
dimensions section on page 9 of this data sheet.
Figure 1. Representative Schematic Diagram
DEVICE MARKING INFORMATION
MC78LXXA
Input
Output
See general marking information in the device marking
section on page 14 of this data sheet.
C *
in
0.33mF
C **
O
Figure 2. Standard Application
A common ground is required between the input and the output voltages. The
input voltage must remain typically 2.0 V above the output voltage even during
the low point on the input ripple voltage.
*C is required if regulator is located an appreciable distance from power
in
supply filter.
** C is not needed for stability; however, it does improve transient response.
O
©
Semiconductor Components Industries, LLC, 2005
1
Publication Order Number:
May, 2005 − Rev. 10
MC78L00A/D