Order this document by MC34055/D
The Motorola 10BASE–T transceiver, designed to comply with the ISO
8802–3 [IEEE 802.3] 10BASE–T specification, will support a Medium
Dependent Interface (MDI) in an embedded Media Attachment Unit (MAU)*.
The interface supporting the Data Terminal Equipment (DTE) is TTL, CMOS,
and raised ECL compatible, and the interface to the Twisted Pair (TP) media
is supported through standard 10BASE–T filters and transformers.
Differential data intended for the TP media is provided a 50 ns pre–emphasis
and data at the TP receiver is screened by Smart Squelch circuitry for
specific threshold, pulse width, and sequence requirements.
10BASE–T TRANSCEIVER
SEMICONDUCTOR
TECHNICAL DATA
Other features of the MC34055 include: Collision and Jabber detection
status outputs, select mode pins for forcing Loop Back and Full–Duplex
operation, a Signal Quality Error pin for testing the collision detect circuitry
without affecting the TP output, and a LED driver for Link Integrity status. An
on–chip oscillator, capable of receiving a clock input or operating under
crystal control, is also provided for internal timing and driving a buffered
clock output.
24
1
The MC34055 is manufactured on a BiCMOS process and is packaged in
a 24 pin SOIC.
DW SUFFIX
PLASTIC PACKAGE
CASE 751E
• BiCMOS Technology for Low Power Operation
• Standard 5.0 V, ± 5% Voltage Supply
(SO–24L)
• Smart Squelch Enforcement of Threshold, Pulse Width, and Sequence
Requirements
• Driver Pre–Emphasis for Output Data
• TTL, CMOS and Raised ECL Compatible
• Interfaces to TP Media with Standard 10BASE–T Filters and
PIN CONNECTIONS
Transformers
• LED Capable Status Outputs for Collision, Jabber Detection, and Link
Integrity
Clk Out
TX Data A
TX Data B
TX EN H
Dig. Gnd
(Dig/Ana)
1
2
24 Clk+
• Directly Driven or Crystal Controlled Clock Oscillator
• Selectable Full–Duplex Operation
• Signal Quality Error Test Pin
23
22
21
20
19
Clk–
SQE EN L
TX+
3
4
• Selectable Loop Back
TX–
5
Pwr Gnd
V
6
CC
Ana. Gnd
RX Data A
RX Data B
RX EN H
Loop L
7
18 Pwr V
CC
MAXIMUM RATINGS (T = 25°C, unless otherwise noted.)
A
8
17 FULLD L
Rating
Power Supply Voltage
Symbol
Value
Unit
Vdc
Vdc
Vdc
9
16
15
14
RX+
V
CC
– 0.5 to 7.0
– 5.25 to 5.25
– 0.5 to 5.5
RX–
10
11
Differential Voltage at RX+/RX–
V
ID
CTL H
Voltage Applied to Logic and Mode/Test
Select Inputs
LNKFL H 12
13 JABB H
Voltage Applied to Logic Outputs and
Output Status Pins
– 0.5 to 7.0
Vdc
Ambient Operating Temperature Range
Junction Temperature
T
0 to 70
°C
°C
A
ORDERING INFORMATION
T
– 65 to 150
J
Operating
Temperature Range
NOTE: Devices should not be operated at these limits. The “Recommended Operating
Conditions” table provides for actual device operation.
Device
Package
MC34055DW
T
A
= 0° to +70°C
SO–24L
Motorola, Inc. 1996
Rev 1
1
MOTOROLA ANALOG IC DEVICE DATA