5秒后页面跳转
捷配首页

Datasheet > MAX9975ARCCQ+TD
MAX9975ARCCQ+TD PDF预览

MAX9975ARCCQ+TD

更新时间： 2024-11-18 19:58:47
品牌 Logo 应用领域
美信 - MAXIM 驱动接口集成电路
页数 文件大小 规格书
32页 879K
描述
Register Based Peripheral Driver, CMOS, PQCC100, ROHS COMPLIANT, PLASTIC, QFN-100

阅读下载

中文翻译

获取价格

MAX9975ARCCQ+TD 技术参数

是否Rohs认证： 符合生命周期：Obsolete
零件包装代码：QFN包装说明：VQCCN, TQFP100,.63SQ
针数：100Reach Compliance Code：compliant
ECCN代码：EAR99HTS代码：8542.39.00.01
风险等级：5.68接口集成电路类型：REGISTER BASED PERIPHERAL DRIVER
JESD-30 代码：S-PQCC-N100JESD-609代码：e3
长度：14 mm标称负供电电压：-4.75 V
功能数量：1端子数量：100
最高工作温度：70 °C最低工作温度：
封装主体材料：PLASTIC/EPOXY封装代码：VQCCN
封装等效代码：TQFP100,.63SQ封装形状：SQUARE
封装形式：CHIP CARRIER, VERY THIN PROFILE峰值回流温度（摄氏度）：260
电源：9.75 V认证状态：Not Qualified
座面最大高度：1 mm子类别：Other Interface ICs
最大供电电压：10.5 V最小供电电压：9.5 V
标称供电电压：9.75 V表面贴装：YES
技术：CMOS温度等级：COMMERCIAL
端子面层：MATTE TIN端子形式：NO LEAD
端子节距：0.5 mm端子位置：QUAD
处于峰值回流温度下的最长时间：30宽度：14 mm
Base Number Matches：1

MAX9975ARCCQ+TD 数据手册

 浏览型号MAX9975ARCCQ+TD的Datasheet PDF文件第2页浏览型号MAX9975ARCCQ+TD的Datasheet PDF文件第3页浏览型号MAX9975ARCCQ+TD的Datasheet PDF文件第4页浏览型号MAX9975ARCCQ+TD的Datasheet PDF文件第5页浏览型号MAX9975ARCCQ+TD的Datasheet PDF文件第6页浏览型号MAX9975ARCCQ+TD的Datasheet PDF文件第7页 
19-0242; Rev 0; 6/05  
Dual, Low-Power, 1200Mbps ATE  
Driver/Comparator with 35mA Load  
General Description  
Features  
♦ Low 1.6W/Channel (typ) Power Dissipation  
The MAX9975 dual, low-power, high-speed, pin elec-  
tronics driver/comparator with 35mA load IC includes,  
for each channel, a three-level pin driver, a dual com-  
parator, variable clamps, and an active load. An addi-  
tional differential comparator allows comparisons  
between the two channels. The driver features a wide  
voltage range and high-speed operation, includes high-  
impedance and active-termination (3rd-level drive)  
modes, and is highly linear even at low voltage swings.  
The dual comparator provides low dispersion (timing  
variation) over a wide variety of input conditions, and  
differential outputs. The clamps provide damping of  
high-speed device-under-test (DUT) waveforms when  
the device is configured as a high-impedance receiver.  
The programmable load supplies up to 35mA of source  
and sink current. The load facilitates contact/continuity  
♦ Greatly Reduced Power Penalty when Load  
Commutated  
♦ High Speed: 1200Mbps at 3V  
and 1800Mbps  
P-P  
at 1V  
P-P  
♦ Programmable 35mA Active-Load Current  
♦ Low Timing Dispersion  
♦ Wide -1.5V to +6.5V (MAX9975AR) or -1.0V to +7.0V  
(MAX9975AZ) Operating Range  
♦ Active Termination (3rd-Level Drive)  
♦ Integrated Clamps  
♦ Integrated Differential Comparator  
♦ Interfaces Easily with Most Logic Families  
♦ Internal 50Ω Termination Resistors  
♦ Low Gain and Offset Errors  
testing, at-speed parametric testing of I  
and I , and  
OL  
OH  
pullup of high-output-impedance devices.  
The MAX9975 provides high-speed, differential control  
inputs and open-collector outputs with internal 50Ω ter-  
mination resistors that make it CML compatible. These  
features significantly reduce the discrete component  
count on the circuit board.  
♦ Comparator Hysteresis Control from 0V to 15mV  
Ordering Information  
A 3-wire, low-voltage, CMOS-compatible serial inter-  
face programs the low-leakage and tri-state/terminate  
operational configurations of the MAX9975.  
PART  
TEMP RANGE  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
PIN-PACKAGE  
100 TQFP-EPR**  
100 TQFP-EPR**  
100 TQFP-EPR**  
100 TQFP-EPR**  
MAX9975ARCCQ  
MAX9975ARCCQ+  
MAX9975AZCCQ*  
MAX9975AZCCQ+*  
The MAX9975ARCCQ operating range is -1.5V to +6.5V.  
The MAX9975AZCCQ operating range is -1.0V to +7.0V.  
The MAX9975 features power dissipation of only 1.6W  
per channel. The device is available in a 100-pin, 14mm  
x 14mm x 0.1mm body, and 0.5mm pitch TQFP. An  
exposed 8mm x 8mm die pad on the top of the package  
facilitates efficient heat removal. The device is specified  
to operate with an internal die temperature of +60°C to  
+100°C, and features a die temperature monitor output.  
*Future product—contact factory for availability.  
**EPR = Exposed pad reversed (TOP).  
+Denotes lead-free package.  
Applications  
Medium-Performance Commodity Memory ATE  
Pin Configuration and Selector Guide appear at end of data sheet.  
________________________________________________________________ Maxim Integrated Products  
1
For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at  
1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com.  
1234567...32

中文翻译

下载PDF

与MAX9975ARCCQ+TD相关器件

型号 品牌 获取价格 描述 数据表
MAX9975ARCCQ-D MAXIM

获取价格

 		Register Based Peripheral Driver, CMOS, PQCC100, PLASTIC, QFN-100
MAX9975ARCCQ-TD MAXIM

获取价格

 		暂无描述
MAX9975AZCCQ MAXIM

获取价格

 		Dual, Low-Power, 1200Mbps ATE Driver/Comparator with 35mA Load
MAX9975AZCCQ+ MAXIM

获取价格

 		Register Based Peripheral Driver, CMOS, 14 X 14 MM, 0.1 MM HEIGHT, 0.50 MM PITCH, LEAD FRE
MAX9977 MAXIM

获取价格

 		Quad, Low-Power, 1200Mbps ATE Driver
MAX9977ADCCQ MAXIM

获取价格

 		暂无描述
MAX9977ADCCQ+ MAXIM

获取价格

 		PWM Based Peripheral Driver, CMOS, PQCC100, ROHS COMPLIANT, PLASTIC, QFN-100
MAX9977AKCCQ MAXIM

获取价格

 		Quad, Low-Power, 1200Mbps ATE Driver
MAX9977AKCCQ+ MAXIM

获取价格

 		暂无描述
MAX9977AKCCQ+D MAXIM

获取价格

 		PWM Based Peripheral Driver, CMOS, PQCC100, ROHS COMPLIANT, PLASTIC, QFN-100

与MAX9975ARCCQ+TD相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证