5秒后页面跳转
MAX9975ARCCQ-D PDF预览

MAX9975ARCCQ-D

更新时间: 2024-11-30 19:58:47
品牌 Logo 应用领域
美信 - MAXIM 驱动接口集成电路
页数 文件大小 规格书
32页 879K
描述
Register Based Peripheral Driver, CMOS, PQCC100, PLASTIC, QFN-100

MAX9975ARCCQ-D 技术参数

是否Rohs认证: 不符合生命周期:Obsolete
零件包装代码:QFN包装说明:PLASTIC, QFN-100
针数:100Reach Compliance Code:not_compliant
ECCN代码:EAR99HTS代码:8542.39.00.01
风险等级:5.74接口集成电路类型:REGISTER BASED PERIPHERAL DRIVER
JESD-30 代码:S-PQCC-N100JESD-609代码:e0
长度:14 mm湿度敏感等级:3
标称负供电电压:-4.75 V功能数量:1
端子数量:100最高工作温度:70 °C
最低工作温度:封装主体材料:PLASTIC/EPOXY
封装代码:VQCCN封装等效代码:TQFP100,.63SQ
封装形状:SQUARE封装形式:CHIP CARRIER, VERY THIN PROFILE
峰值回流温度(摄氏度):245电源:9.75 V
认证状态:Not Qualified座面最大高度:1 mm
子类别:Other Interface ICs最大供电电压:10.5 V
最小供电电压:9.5 V标称供电电压:9.75 V
表面贴装:YES技术:CMOS
温度等级:COMMERCIAL端子面层:TIN LEAD
端子形式:NO LEAD端子节距:0.5 mm
端子位置:QUAD处于峰值回流温度下的最长时间:NOT SPECIFIED
宽度:14 mmBase Number Matches:1

MAX9975ARCCQ-D 数据手册

 浏览型号MAX9975ARCCQ-D的Datasheet PDF文件第2页浏览型号MAX9975ARCCQ-D的Datasheet PDF文件第3页浏览型号MAX9975ARCCQ-D的Datasheet PDF文件第4页浏览型号MAX9975ARCCQ-D的Datasheet PDF文件第5页浏览型号MAX9975ARCCQ-D的Datasheet PDF文件第6页浏览型号MAX9975ARCCQ-D的Datasheet PDF文件第7页 
19-0242; Rev 0; 6/05  
Dual, Low-Power, 1200Mbps ATE  
Driver/Comparator with 35mA Load  
General Description  
Features  
Low 1.6W/Channel (typ) Power Dissipation  
The MAX9975 dual, low-power, high-speed, pin elec-  
tronics driver/comparator with 35mA load IC includes,  
for each channel, a three-level pin driver, a dual com-  
parator, variable clamps, and an active load. An addi-  
tional differential comparator allows comparisons  
between the two channels. The driver features a wide  
voltage range and high-speed operation, includes high-  
impedance and active-termination (3rd-level drive)  
modes, and is highly linear even at low voltage swings.  
The dual comparator provides low dispersion (timing  
variation) over a wide variety of input conditions, and  
differential outputs. The clamps provide damping of  
high-speed device-under-test (DUT) waveforms when  
the device is configured as a high-impedance receiver.  
The programmable load supplies up to 35mA of source  
and sink current. The load facilitates contact/continuity  
Greatly Reduced Power Penalty when Load  
Commutated  
High Speed: 1200Mbps at 3V  
and 1800Mbps  
P-P  
at 1V  
P-P  
Programmable 35mA Active-Load Current  
Low Timing Dispersion  
Wide -1.5V to +6.5V (MAX9975AR) or -1.0V to +7.0V  
(MAX9975AZ) Operating Range  
Active Termination (3rd-Level Drive)  
Integrated Clamps  
Integrated Differential Comparator  
Interfaces Easily with Most Logic Families  
Internal 50Ω Termination Resistors  
Low Gain and Offset Errors  
testing, at-speed parametric testing of I  
and I , and  
OL  
OH  
pullup of high-output-impedance devices.  
The MAX9975 provides high-speed, differential control  
inputs and open-collector outputs with internal 50Ω ter-  
mination resistors that make it CML compatible. These  
features significantly reduce the discrete component  
count on the circuit board.  
Comparator Hysteresis Control from 0V to 15mV  
Ordering Information  
A 3-wire, low-voltage, CMOS-compatible serial inter-  
face programs the low-leakage and tri-state/terminate  
operational configurations of the MAX9975.  
PART  
TEMP RANGE  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
PIN-PACKAGE  
100 TQFP-EPR**  
100 TQFP-EPR**  
100 TQFP-EPR**  
100 TQFP-EPR**  
MAX9975ARCCQ  
MAX9975ARCCQ+  
MAX9975AZCCQ*  
MAX9975AZCCQ+*  
The MAX9975ARCCQ operating range is -1.5V to +6.5V.  
The MAX9975AZCCQ operating range is -1.0V to +7.0V.  
The MAX9975 features power dissipation of only 1.6W  
per channel. The device is available in a 100-pin, 14mm  
x 14mm x 0.1mm body, and 0.5mm pitch TQFP. An  
exposed 8mm x 8mm die pad on the top of the package  
facilitates efficient heat removal. The device is specified  
to operate with an internal die temperature of +60°C to  
+100°C, and features a die temperature monitor output.  
*Future product—contact factory for availability.  
**EPR = Exposed pad reversed (TOP).  
+Denotes lead-free package.  
Applications  
Medium-Performance Commodity Memory ATE  
Pin Configuration and Selector Guide appear at end of data sheet.  
________________________________________________________________ Maxim Integrated Products  
1
For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at  
1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com.  

与MAX9975ARCCQ-D相关器件

型号 品牌 获取价格 描述 数据表
MAX9975ARCCQ-TD MAXIM

获取价格

暂无描述
MAX9975AZCCQ MAXIM

获取价格

Dual, Low-Power, 1200Mbps ATE Driver/Comparator with 35mA Load
MAX9975AZCCQ+ MAXIM

获取价格

Register Based Peripheral Driver, CMOS, 14 X 14 MM, 0.1 MM HEIGHT, 0.50 MM PITCH, LEAD FRE
MAX9977 MAXIM

获取价格

Quad, Low-Power, 1200Mbps ATE Driver
MAX9977ADCCQ MAXIM

获取价格

暂无描述
MAX9977ADCCQ+ MAXIM

获取价格

PWM Based Peripheral Driver, CMOS, PQCC100, ROHS COMPLIANT, PLASTIC, QFN-100
MAX9977AKCCQ MAXIM

获取价格

Quad, Low-Power, 1200Mbps ATE Driver
MAX9977AKCCQ+ MAXIM

获取价格

暂无描述
MAX9977AKCCQ+D MAXIM

获取价格

PWM Based Peripheral Driver, CMOS, PQCC100, ROHS COMPLIANT, PLASTIC, QFN-100
MAX9977AKCCQ+TD MAXIM

获取价格

PWM Based Peripheral Driver, CMOS, PQCC100, ROHS COMPLIANT, PLASTIC, QFN-100