EVALUATION KIT AVAILABLE
MAX16922
2.2MHz, Dual, Step-Down DC-DC
Converters, Dual LDOs, and RESET
General Description
Benefits and Features
● 1.2A High-Efficiency 2.2MHz DC-DC Converter
• 3.7V to 28V Operating Supply Voltage
• 45V Load-Dump Protection
The MAX16922 power-management integrated circuit
(PMIC) is designed for medium-power-level automotive
applications, and integrates multiple supplies in a small
footprint. The device includes one high-voltage step-
down converter (OUT1) and three low-voltage cascaded
DC-DC converters (OUT2, OUT3, OUT4). OUT1 and
OUT2 are step-down DC-DC converters, and OUT3/
OUT4 are linear regulators. The device also includes
a reset output (RESET) and a high-voltage-compatible
enable input (EN).
• Output Voltage: 3.0V to 5.5V
● 600mA High-Efficiency 2.2MHz DC-DC Converter
• 2.7V to 5.5V Supply Voltage
• Output Voltage: 1.0V to 3.9V
• 180° Out-of-Phase Operation
• Forced-PWM and Auto-PWM Modes
● LDO Linear Regulators
The 1.2A output high-efficiency, step-down DC-DC con-
verter (OUT1) operates from a voltage up to 28V con-
tinuous and is protected from load-dump transients up to
45V. The 600mA output high-efficiency step-down DC-DC
converter (OUT2) runs from a voltage up to 5.5V. The two
300mA LDO linear regulators offer low dropout of only
130mV (typ). The power-good RESET output provides
voltage monitoring for OUT1 and OUT2.
• OUT3: 1.0V to 4.15V at 300mA
• OUT4: 1.0V to 4.15V at 300mA
• Separate Inputs for Increased Efficiency
● Enable Input
●
RESET Output Monitoring on OUT1 and OUT2
● Overtemperature and Short-Circuit Protection
● Available in
OUT1 and OUT2 use fast 2.2MHz PWM switching and
small external components. The high-voltage converter
(OUT1) enters skip mode automatically under light loads
to prevent an overvoltage condition from occurring at the
output. The low-voltage synchronous DC-DC converter
(OUT2) can operate in forced-PWM mode to prevent any
AM band interference or high-efficiency auto-PWM mode.
5mm x 5mm x 0.8mm, 20-Pin TQFN-EP
4.5mm x 6.5mm, 20-Pin TSSOP-EP
Typical Operating Circuit
V
PV1
PV1
EN
OUTS2
LX2
2.2µH
4.7µF
The MAX16922 includes overtemperature shutdown and
overcurrent limiting. The device is designed to operate
from -40°C to +125°C ambient temperature.
V
OUT2
10µF
PWM
PV3
V
OUT1
PGND2
PV2
BST
4.7µF
MAX16922
4.7µF
0.1µF
4.7µH
V
OUT3
GND1
GND3
OUT3
4.7µF
LX1
V
OUT1
V
OUT2
OUTS1
PV4
10µF
4.7µF
V
OUT1
LSUP
V
OUT4
GND
OUT4
4.7µF
1µF
20kΩ
GND2
RESET
EP
Ordering Information appears at end of data sheet.
19-5039; Rev 11; 6/18