EVALUATION KIT AVAILABLE
MAX15096/MAX15096A/
MAX15096D
2.7V to 18V, 6A Integrated Hot-Swap/Electronic
Circuit Breaker
General Description
Features
The MAX15096/MAX15096A/MAX15096D ICs are inte-
grated solutions for hot-swap applications requiring the
safe insertion and removal of circuit line cards from a live
backplane. They can also be used as electronics circuit
breaker for hard drive and solid-state drive and fans. The
devices integrate a hot-swap controller, 12mΩ (typ) power
MOSFET, and an electronic circuit-breaker protection in a
single package.
● 2.7V to 18V Operating Voltage Range
● 12mΩ (typ) Internal Power MOSFET
● 6A (typ) Load-Current Capability
● ±10% Circuit-Breaker Threshold Accuracy
● Programmable Inrush Current Control Under SOA
Operation
● Adjustable Circuit-Breaker Current/Current-Limit
The devices are designed for protection of 2.7V to 18V
supply voltages. These devices implement a foldback
current limit during startup to control inrush current, lower-
ing di/dt and keeping the MOSFET operating under safe
operating area (SOA) conditions. After the startup cycle
is complete, on-chip comparators provide VariableSpeed/
BiLevel™ protection against short-circuit and overcur-
rent faults, and immunity against system noise and load
transients. The load is disconnected in the event of a fault
condition. The devices are factory calibrated to deliver
accurate overcurrent protection with ±10% accuracy.
During a fault condition, PG goes low and the devices
latch off (MAX15096) or automatic retry (MAX15096A);
the output could also be discharged after a fault event
(MAX15096D).
Threshold
● Programmable Slew-Rate Control
● Variable-Speed Circuit-Breaker Response
● Thermal Protection
● Programmable Overvoltage Protection and
Undervoltage-Lockout Threshold
● Latchoff or Automatic Retry Options
● Drive Present Signal Input
● Enable Input (EN)
● IN-to-OUT Short-Circuit Detection
● Open-Drain PG Output
● Output Discharge After a Fault Event
The devices feature an IN-to-OUT short-circuit detection
before startup. The devices provide a power-MOSFET
GATE pin to program the slew rate during startup by
adding an external capacitor. The devices have an under-
voltage/overvoltage input pin (UVOV) that can detect an
undervoltage/overvoltage fault and disconnect the IN from
the OUT. Additional features include internal overtem-
perature protection and a power-good output (PG).
(MAX15096D Only)
● Programmable Additional Delay (2μs max) to Fast-
Comparator Response Time Through External
Resistor on TIMER Pin
Applications
● Blade Servers
● Server I/O Cards
● RAID Systems
● Disk Drive Power
● StorageApplications
● IndustrialApplications
The devices are available in a 16-bump, 2mm x 2mm
wafer-level package (WLP) and are rated over the -40°C
to +105°C extended temperature range.
Ordering Information appears at end of data sheet.
VariableSpeed/BiLevel is a trademark of Maxim Integrated
Products, Inc.
19-7304; Rev 0; 3/14