5秒后页面跳转
LUCL9216AGF-D PDF预览

LUCL9216AGF-D

更新时间: 2024-11-24 22:05:27
品牌 Logo 应用领域
杰尔 - AGERE 电池电信集成电路
页数 文件大小 规格书
48页 1018K
描述
Short-Loop Ringing SLIC with Ground Start

LUCL9216AGF-D 数据手册

 浏览型号LUCL9216AGF-D的Datasheet PDF文件第2页浏览型号LUCL9216AGF-D的Datasheet PDF文件第3页浏览型号LUCL9216AGF-D的Datasheet PDF文件第4页浏览型号LUCL9216AGF-D的Datasheet PDF文件第5页浏览型号LUCL9216AGF-D的Datasheet PDF文件第6页浏览型号LUCL9216AGF-D的Datasheet PDF文件第7页 
Preliminary Data Sheet  
September 2001  
L9216A/G  
Short-Loop Ringing SLIC with Ground Start  
Applications  
Introduction  
Voice over Internet Protocol (VoIP)  
Cable Modems  
The Agere Systems Inc. L9216 is a subscriber line  
interface circuit (SLIC) that is optimized for short-  
loop, power-sensitive applications. This device pro-  
vides the complete set of line interface functionality,  
including power ringing needed to interface to a sub-  
scriber loop. This device has the capability to operate  
with a VCC supply of 3.3 V or 5 V and is designed to  
minimize external components required at all device  
interfaces.  
Terminal Adapters (TA)  
Wireless Local Loop (WLL)  
Telcordia TechnologiesGR-909 Access  
Network Termination (NT)  
Key Systems  
Features  
Description  
Onboard ringing generation  
This device is optimized to provide battery feed, ring-  
ing, and supervision on short-loop plain old tele-  
phone service (POTS) loops.  
Three ringing input options:  
— Sine wave  
— PWM  
— Logic level square wave  
This device provides power ring to the subscriber  
loop through amplification of a low-voltage input. It  
provides forward and reverse battery feed states, on-  
hook transmission, a low-power scan state, ground  
start (tip open), and a forward disconnect state.  
Flexible VCC options:  
— 5 V or 3.3 V VCC  
— No –5 V required  
Battery switch to minimize off-hook power  
The device requires a VCC and battery to operate.  
VCC may be either a 5 V or a 3.3 V supply. The ring-  
ing signal is derived from the high-voltage battery. A  
battery switch is included to allow for use of a lower-  
voltage battery in the off-hook mode, thus minimizing  
short-loop off-hook power.  
Eight operating states:  
— Scan mode for minimal power dissipation  
— Forward and reverse battery active  
— On-hook transmission states  
— Ground start (tip open)  
— Ring mode  
— Disconnect mode  
Loop closure, ring trip, and ground start detectors are  
available. The loop closure detector has a fixed  
threshold with hysteresis. The ring trip detector  
requires a single-pole filter, thus minimizing external  
components required.  
Ultralow on-hook power:  
— 27 mW scan mode  
— 41 mW active mode  
Two SLIC gain options to minimal external compo-  
nents in codec interface  
The dc current limit is set and fixed by a logic control-  
lable pin. Ground or open is applied to this pin set the  
current limit at the low or high value.  
Loop start, ring trip, and ground start detectors  
Software-controllable dual current-limit option  
28-pin PLCC package  
The device is offered with two gain options. This  
allows for an optimized codec interface, with minimal  
external components regardless of whether a first-  
generation or a programmable third-generation  
codec is used.  
48-pin MLCC package  

与LUCL9216AGF-D相关器件

型号 品牌 获取价格 描述 数据表
LUCL9216AGF-DT AGERE

获取价格

Short-Loop Ringing SLIC with Ground Start
LUCL9216ARG-D AGERE

获取价格

Short-Loop Ringing SLIC with Ground Start
LUCL9216BGF-DT ZARLINK

获取价格

SLIC, PQCC28, PLASTIC, LCC-28
LUCL9216GGF-D AGERE

获取价格

Short-Loop Ringing SLIC with Ground Start
LUCL9216GGF-DT AGERE

获取价格

Short-Loop Ringing SLIC with Ground Start
LUCL9216GRG-D AGERE

获取价格

Short-Loop Ringing SLIC with Ground Start
LUCL9216HGF-D ZARLINK

获取价格

SLIC, PQCC28, PLASTIC, LCC-28
LUCL9217AAR-D AGERE

获取价格

Low-Cost Line Interface with Reverse Battery and PPM
LUCL9217AAR-DT AGERE

获取价格

Low-Cost Line Interface with Reverse Battery and PPM
LUCL9217GAR-D AGERE

获取价格

Low-Cost Line Interface with Reverse Battery and PPM