5秒后页面跳转
LUCL8574DP-D PDF预览

LUCL8574DP-D

更新时间: 2024-11-20 22:17:51
品牌 Logo 应用领域
杰尔 - AGERE 继电器
页数 文件大小 规格书
36页 461K
描述
L8574D Resistive Subscriber Line Interface Circuit(SLIC), Ring Relay,and Protector(SRP)for Long Loop and TR-57 Applications

LUCL8574DP-D 数据手册

 浏览型号LUCL8574DP-D的Datasheet PDF文件第2页浏览型号LUCL8574DP-D的Datasheet PDF文件第3页浏览型号LUCL8574DP-D的Datasheet PDF文件第4页浏览型号LUCL8574DP-D的Datasheet PDF文件第5页浏览型号LUCL8574DP-D的Datasheet PDF文件第6页浏览型号LUCL8574DP-D的Datasheet PDF文件第7页 
Data Sheet  
October 1998  
L8574D Resistive Subscriber Line Interface Circuit (SLIC), Ring  
Relay, and Protector (SRP) for Long Loop and TR-57 Applications  
Included in the L8574 are a solid-state ringing  
access switch and a line break switch. Also included  
Features  
is a relay driver for an external (test) access mechan-  
ical relay.  
Low-power scan mode for low on-hook power dis-  
sipation (55 mW max)  
State control is via four latched parallel data inputs. A  
Low active power dissipation; talk or on-hook  
chip select feature allows the user to enable, disable,  
transmission (240 mW max)  
or reset the data latches to a known logic state.  
Distortion-free on-hook transmission  
The L8574 offers a low-power scan state to minimize  
power to less than 55 mW in the on-hook state. The  
L8574 also supports on-hook transmission. The  
Eight operating states via latched paralleled data  
inputs with channel select feature  
active power in both the talk or on-hook transmission  
mode is also very low (<240 mW). Current is limited  
to a fixed value of 25 mA by an internal precision  
Precision fixed 28 mA current limiter  
Integrated protection  
current-limit circuit.  
No external protection device required  
Because of the internal architecture of the L8574  
SLIC and because of the power rating of the associ-  
ated external feed resistors, the L8574 will meet most  
Integrated ringing access relay  
Ring trip detector  
surge requirements without use of an external sec-  
ondary protection device. Internal circuitry steers  
both positive and negative faults to fault ground. Neg-  
Loop closure detector with hysteresis  
Relay driver  
ative faults are not dumped into battery.  
Battery noise cancellation  
The L8574 is a two-chip line interface solution pack-  
aged in a single, 44-pin PLCC package. The Tip and  
Ring drive amplifiers, the XMT amplifier, the receive  
Thermal protection  
44-pin, surface-mount, plastic package (PLCC)  
interface, and battery noise cancellation circuits are  
fabricated in a 90 V complementary bipolar (CBIC)  
Description  
process. The ring access switch, line break switch,  
battery switch, current-limit, protection functions,  
supervision, and control functions are fabricated in a  
320 V dielectrically isolated bipolar-CMOS-DMOS  
(BCDMOS) process. The device is available in a  
44-pin PLCC package.  
The L8574 is a resistive subscriber line interface cir-  
cuit (SLIC) that is optimized for long loop applica-  
tions, such as Bellcore TR-NWT-000057  
requirements for digital loop carrier (DLC) applica-  
tions. It interfaces the low-voltage circuits on an ana-  
log line card to the Tip/Ring subscriber loop. The  
L8574 does not supply dc current to the subscriber  
loop; external resistors are used for this purpose.  

与LUCL8574DP-D相关器件

型号 品牌 获取价格 描述 数据表
LUCL8574DP-DT AGERE

获取价格

L8574D Resistive Subscriber Line Interface Circuit(SLIC), Ring Relay,and Protector(SRP)for
LUCL8575BP AGERE

获取价格

Dual-Resistive,Low-Cost Subscriber Line Interface Circuit(SLIC)
LUCL8575BP-TR AGERE

获取价格

Dual-Resistive,Low-Cost Subscriber Line Interface Circuit(SLIC)
LUCL8576BP-D AGERE

获取价格

Dual Ringing SLIC
LUCL8576BP-DT AGERE

获取价格

Dual Ringing SLIC
LUCL9214AA-DT AGERE

获取价格

Low-Cost Ringing SLIC
LUCL9214AAJ-D AGERE

获取价格

Low-Cost Ringing SLIC
LUCL9214AAJ-DT AGERE

获取价格

Low-Cost Ringing SLIC
LUCL9214AAU-D AGERE

获取价格

Low-Cost Ringing SLIC
LUCL9214ARG-D AGERE

获取价格

Low-Cost Ringing SLIC